Soleus Air GM-WAC-10ESE-C Troubleshooting, Problem, Possible Causes, Solutions, as it should

Page 16
TROUBLESHOOTING

TROUBLESHOOTING

PROBLEM

POSSIBLE CAUSES

SOLUTIONS

 

 

 

The Air Conditioner will not start

The air conditioner is unplugged

• Make sure the air conditioner is

 

 

plug is pushed completely into the

 

 

outlet

The fuse is blown/circuit breaker is tripped.

Check the house fuse/circuit breaker box and replace the fuse or reset the breaker.

Power Failure

• The unit will automatically re-start

 

when power is restored.

 

• There is a protective time delay

 

(approx. 3 minutes) to prevent

 

tripping of the compressor

 

overload. For this reason, the unit

 

may not start normal cooling for 3

 

minutes after it is turned back on.

 

 

The current interrupter device is tripped.

Press the RESET button located on the power cord plug.

If the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.

The Air Conditioner does not cool

Airflow is restricted

• Make sure there are no curtains,

as it should

 

blinds, or furniture blocking the

 

 

front of the air conditioner

 

 

 

 

The temperature control may not be

• Lower the set thermostat tempera-

 

set correctly.

ture

 

 

 

 

The air filter is dirty

• Clean the filter. See the Cleaning

 

 

and Care Section of the manual.

 

 

 

 

The room may be too warm

• Please allow time for the room to

 

 

cool down after turning on the air

 

 

conditioner.

 

 

 

 

Cold air is escaping

• Check for open furnace registers

 

 

and cold air returns

 

 

 

 

The Cooling Coils are frozen

• See “Air Conditioner Freezing Up”

 

 

below.

The Air Conditioner is freezing up

Ice blocks the air flow and stops the air

• Set the MODE dial to HIGH FAN

 

conditioner from cooling the room

or HIGH COOL and set the ther-

 

 

mostat to a higher temperature

 

The batteries are inserted incorrectly

 

The Remote Control is not working

• Check the position of the batteries.

 

The batteries may be dead

• Replace the batteries

 

 

 

15

Image 16
Contents Electronic Window Air Conditioner Models GM-WAC-10ESE-C GM-WAC-12ESE-COperating Instructions Page IMPORTANT SAFETY INSTRUCTIONS ELECTRICAL REQUIREMENTS LCDI Power Cord and PlugRecommended Ground Method It is the customer’s responsibilityPACKING LIST Packing ListSPECIFICATIONS DISCLAIMERModel GM-WAC-10ESE-CINSTALLATION & ASSEMBLY INSTRUCTIONS Mounting Hardware How to InstallTOOLS NEEDED FIG. 3AFIG. FIG FIG. FIG. 6AFIG. FIG AIR CONDITIONER USE If AC is Blocked by Storm WindowRemoving AC From Window Electronic Control Panel & Remote Control USING YOUR AIR CONDITIONERAir Conditioner Controls Normal Operating Sounds OPERATING YOUR AIR CONDITIONER REMOTE CONTROL9.LOCK/UNLOCK- Press the “+” and “-”buttons simultaneously to lock and unlock the remote control. When the remote is locked, none of the functions or setting can be changed using the remote REMOTE CONTROLOPERATING YOUR AIR CONDITIONER USING YOUR AIR CONDITIONER Cont CARE AND CLEANING Air Filter CleaningCabinet Cleaning Winter StorageTROUBLESHOOTING PROBLEMSOLUTIONS The Remote Control is not workingTROUBLESHOOTING CONT PROBLEMSOLUTIONS POSSIBLE CAUSESWarranty