Setting up for computer to communicate with a
You need to configure the computer connections so it can communicate with your
Connect an IR emitter (blaster) cable to the computer and your
The IR emitter cable is a remote control sensing device that connects to the computer and covers the remote sensor on a
1Connect the IR emitter cable (A) to the IR Out connector (D) on the back of the computer.
2Remove the paper from the backing tape on the end of the cable (B), and then press the end of the cable over the remote IR sensor (receiver) window on the
3When you use the remote control, point it at the front of the HP TouchSmart PC (E), not at the
C
A
D E
B