HP VS803UT manual Type

Page 56

NOTE: On some computer models, it may be necessary to remove an internal component to gain access to the battery.

8.Depending on the type of battery holder on the system board, complete the following instructions to replace the battery.

Type 1

a.Lift the battery out of its holder.

Figure B-1Removing a Coin Cell Battery (Type 1)

b.Slide the replacement battery into position, positive side up. The battery holder automatically secures the battery in the proper position.

Type 2

a.To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1).

b.To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2).

Figure B-2Removing and Replacing a Coin Cell Battery (Type 2)

Type 3

a.Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).

50 Appendix B Battery Replacement

ENWW

Image 56

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Product Features Standard Configuration FeaturesFront Panel Components 1Front Panel ComponentsMedia Card Reader Components 2Media Card Reader ComponentsRear Panel Components 3Rear Panel ComponentsUsing the Windows Logo Key Keyboard4Keyboard Components 5Windows Logo Key FunctionsArrow Serial Number Location 6Serial Number and Product ID LocationHardware Upgrades Serviceability FeaturesUnlocking the Smart Cover Lock Smart Cover FailSafe Key1Removing the Smart Cover Lock Screw Removing the Computer Access Panel Replacing the Computer Access Panel 3Replacing the Access Panel Hardware UpgradesRemoving the Front Bezel 5Removing a Bezel Blank Hardware Upgrades Removing Bezel BlanksReplacing the Front Bezel 6Replacing the Front BezelUsing the Small Form Factor Computer in a Tower Orientation DDR3-SDRAM DIMMs Installing Additional MemoryDIMMs Populating Dimm Sockets 1DIMM Socket LocationsInstalling DIMMs 9Rotating the Drive Cage Up Hardware Upgrades Enww Removing or Installing an Expansion Card 2Expansion Slot Locations12Opening the Expansion Slot Retainer 13Removing an Expansion Slot Cover Hardware Upgrades 14Removing a Standard PCI Expansion Card Enww Enww Drive Positions 3Drive PositionsInstalling and Removing Drives 19Extra Guide Screw LocationsSystem Board Drive Connections 4System Board Drive ConnectionsRemoving an External 5.25-inch Drive Enww Installing an Optical Drive into the 5.25-inch Drive Bay 24Removing the 5.25-inch Drive26Installing the Optical Drive Hardware Upgrades Enww Removing an External 3.5-inch Drive 30Disconnecting the Media Card Reader USB Cable Installing a Drive into the 3.5-inch External Drive Bay Enww Enww 38Installing Hard Drive Guide Screws Removing and Replacing a Removable 3.5-inch Sata Hard Drive 41Removing the Thermal Sensor Enww Enww Enww Specifications Table A-1SpecificationsAppendix a Specifications Battery Replacement Type Enww HP/Kensington MicroSaver Security Cable Lock Installing a Security LockExternal Security Devices Padlock HP Business PC Security LockEnww Front Bezel Security Figure C-6Engaging the LockEnww Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Computer Operating Guidelines and Routine Care Optical Drive Precautions CleaningSafety Shipping PreparationIndex ComputerEnww