HP VS803UT manual Enww

Page 45

3.Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place.

Figure 2-33Installing a Drive into the 3.5-inch Drive Bay (Media Card Reader Shown)

4.Connect the appropriate drive cables:

a.If installing a second hard drive, connect the power and data cables to the rear of the drive and connect the other end of the data cable to the next available (unpopulated) SATA connector on the system board by following the numbered sequence of the connectors.

b.If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board labeled MEDIA. If the media card reader includes a 1394 port, connect the 1394 cable to the 1394 PCI card.

NOTE: Refer to System Board Drive Connections on page 30 for an illustration of the system board drive connectors.

5.Replace the 5.25-inch drive.

6.Replace the front bezel and access panel.

7.If the computer was on a stand, replace the stand.

8.Reconnect the power cord and turn on the computer.

9.Lock any security devices that were disengaged when the access panel was removed.

Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive

NOTE: The system does not support Parallel ATA (PATA) hard drives.

Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive.

The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the hard drive:

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as compact discs or USB flash drives, from the computer.

3.Turn off the computer properly through the operating system, then turn off any external devices.

ENWW	Installing and Removing Drives 39

Image 45

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Standard Configuration Features Product Features1Front Panel Components Front Panel Components2Media Card Reader Components Media Card Reader Components3Rear Panel Components Rear Panel ComponentsKeyboard Using the Windows Logo Key4Keyboard Components 5Windows Logo Key FunctionsArrow 6Serial Number and Product ID Location Serial Number LocationServiceability Features Hardware UpgradesSmart Cover FailSafe Key Unlocking the Smart Cover Lock1Removing the Smart Cover Lock Screw Removing the Computer Access Panel 3Replacing the Access Panel Hardware Upgrades Replacing the Computer Access PanelRemoving the Front Bezel Removing Bezel Blanks 5Removing a Bezel Blank Hardware Upgrades6Replacing the Front Bezel Replacing the Front BezelUsing the Small Form Factor Computer in a Tower Orientation Installing Additional Memory DIMMsDDR3-SDRAM DIMMs 1DIMM Socket Locations Populating Dimm SocketsInstalling DIMMs 9Rotating the Drive Cage Up Hardware Upgrades Enww 2Expansion Slot Locations Removing or Installing an Expansion Card12Opening the Expansion Slot Retainer 13Removing an Expansion Slot Cover Hardware Upgrades 14Removing a Standard PCI Expansion Card Enww Enww 3Drive Positions Drive Positions19Extra Guide Screw Locations Installing and Removing Drives4System Board Drive Connections System Board Drive ConnectionsRemoving an External 5.25-inch Drive Enww 24Removing the 5.25-inch Drive Installing an Optical Drive into the 5.25-inch Drive Bay26Installing the Optical Drive Hardware Upgrades Enww Removing an External 3.5-inch Drive 30Disconnecting the Media Card Reader USB Cable Installing a Drive into the 3.5-inch External Drive Bay Enww Enww 38Installing Hard Drive Guide Screws Removing and Replacing a Removable 3.5-inch Sata Hard Drive 41Removing the Thermal Sensor Enww Enww Enww Table A-1Specifications SpecificationsAppendix a Specifications Battery Replacement Type Enww Installing a Security Lock External Security DevicesHP/Kensington MicroSaver Security Cable Lock HP Business PC Security Lock PadlockEnww Figure C-6Engaging the Lock Front Bezel SecurityEnww Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Computer Operating Guidelines and Routine Care Cleaning Optical Drive PrecautionsSafety Shipping PreparationComputer IndexEnww