HP NRM42 manual LAN and WAN Port Addresses, Information from your ISP

3.3 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.

LAN Port

WAN Port

IP address

Subnet Mask

DHCP server function

IP addresses for distribution to PCs

192.168.0.1

255.255.255.0

Enabled

100 IP addresses continuing from 192.168.0.100 through 192.168.0.199

The PPPoE function is enabled to automatically get the WAN port configuration from the ISP, but you have to set the username and password first.

3.4 Information from your ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, or IPoA.

Gather the information as illustrated in the following table and keep it for reference.

PPPoE

PPPoA

RFC1483 Bridged

RFC1483 Routed

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, Service Name, and Domain Name System (DNS) IP address (it can be automatically assigned by your ISP when you connect or be set manually).

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, and Domain Name System (DNS) IP address (it can be automatically assigned by your ISP when you connect or be set manually).

VPI/VCI, VC-based/LLC-based multiplexing to use Bridged Mode.

VPI/VCI, VC-based/LLC-based multiplexing, IP address, Subnet mask, Gateway address, and Domain Name System (DNS) IP address (it is fixed IP address).

16