HP 13-3018ca Ultrabook, 13-3001xx Ultrabook, 13-3010dx Ultrabook manual Power connector cable

Power connector cable

Description	Spare part number
Power connector cable	744362-001

Before removing the power connector cable, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the following components:

a.Bottom cover (see Bottom cover on page 29)

b.Battery (see Battery on page 46)

c.WLAN module (see WLAN module on page 32)

d.Fan (see Fan on page 41)

e.System board (see System board on page 48)

Remove the power connector cable:

1.Remove the Phillips PM2.0×3.0 screw (1) that secures the power connector cable to the computer.

2.Lift the bracket from atop the connector (2).

3.Lift the connector straight up and out of the computer (3).

Reverse this procedure to install the power connector cable.

Component replacement procedures 51