Sterling SDF 400, SDF 250, SDF 500 manual Assembly instructions

Page 60

SDF 250/400/500

8. Assembly instructions

￿These installation instructions are intended for persons with skills in electrical and mechanical areas due to their training, experience and received instructions.

Personnel using these installation instructions must be instructed in the regulations for the prevention of accidents, the operating conditions and safety regulations and their implementation.

Ensure in each case that the personnel are informed.

The installation instructions provided in the corresponding operating instructions apply for all connected equipment.

Observe safety regulations with regard to lifting gear handling.

All installation work must be carried out with the equipment disconnected from electrical power and compressed air supply.

L

F

For installation work taking place at heights of over approx. 6 feet (1829mm), use only ladders or similar equipment and working platforms intended for this purpose. At greater heights, the proper equipment for protection against falling must be worn.

Use only suitable lifting gear which is in proper working order and load suspension devices with sufficient carrying capacity. Do not stand or work under suspended loads!

Use suitable workshop equipment.

Install the equipment such that all parts are easily accessible; this facilitates maintenance and repair work.

Assembly instructions 8-1

Image 60
Contents Sterling Material Processing SDF 250/400/500 SDF 250/400/500 Table of contents 10-1 General Information SDF 250/400/500 SDF 250/400/500 Explanations and information Legal basisFields of applications Safety instructions General Assembly OperationMaintenance For the safety of the devices Start up Control Unit Touch ScreenSwitching on the Dryer Basic parameters Entering Dryer ValuesHeater Reg. Act Exit air ActDew point max Dew point ActEntering hopper values Hopper temp Target Hopper temp ActGranule Temp Drying time TargetSetting the timer Timer is only operating, when the dryer is switched on Actual hopper temperature displayed in C Status dryer Observing processing statusActual operation status Setting date and time Changing language SDF 250/400/500 Continuous operation SDF 250/400/500 Start up Switching the dryer/hopper heater off Error and error correction LED Alarm Actual messages Error Bypass Flap Error Valve BlockTemperature Measurement Outgoing Air Defective Excess Temperature Return AirExcess Temperature Heater Hopper Insufficient Temperature Heater HopperTemperature Measurement Granules Defective Hopper Excess Temperature Granules HopperMain switch hopper heater # Controller is off Overload Regeneration Heater STB has been activatedOverload Drying Heater STB has been activated Alarm protocol Maintenance SDF 250/400/500 Maintenance schedule Cleaning or Replacing the Air Filter Cleaning or Replacing the Return Air Filter SDF DryerCleaning or Replacing the Regeneration air filter Filter of the electrical cabinet Disposing of Drying Agents Cleaning the Drying Hopper Remove any granules remaining in the cleaning opening STTSTT 60 Changing the battery of the control system Notch on the battery connector must point to the leftSDF 250/400/500 Resetting the control values Functional description Dew point dependent regeneration switch optional General InformationDrying Hopper Optional Hopper heaters optionalConnection to a Pneumatic Conveying System Optional Return Air Cooler OptionalTransport, Assembly and Storage Tansport and Packing Transport with a fork lift truckTransport with a workshop crane Assembly StorageAssembly instructions Connection of Return Air Cooler Optional Electrical Connection Compressed Air Supply Technical data Basic VersionOptional Equipment PerformanceSDF 250/400/500 Accessories Accessories Spare parts list Drying Hoppers STT 25 STT STT 25 STT STT 25 STT STT 25 STT STT 25 STT STT 25 STT