HP 1230 manual Clearing the Power-on Password

Maintenance & Service Guide

Presario 1200 Series

Models: 1230 and 1232

Home Page Notice Preface Product Description Troubleshooting Illustrated Parts Catalog Removal & Replacement Procedures Specifications Pin Assignments Battery Pack Operations

Clearing the Power-on Password

Clearing the power-on password requires removing all Setup attributes that are programmed in the CMOS. The RTC battery is located on the system board.

If the password is not known, clear it by performing the following steps:

1. Turn off the computer.

2. Disconnect the power cord.

3. Remove the battery pack.

4. Remove the Palmrest Cover with Touch Pad.

5. Remove the heatspreader.

6. Remove the keyboard.

7. The dip switch contains four bits. Set the third bit to ON for 30 seconds and return it to OFF position.

8. Reassemble the computer.

9. Turn on the computer to verify that the power-on password has been cleared. If it has not been cleared, repeat Steps 1 through 10.