HP CQ10-610CA, CQ10-689NR, CQ10-688NR manual Hard drive

Hard drive

Description	Spare part number
Hard drive only (does not include bracket, cover, or screws):
500-GB, 7200-rpm, 7.0-mm	634925-001
320-GB, 7200-rpm, 7.0-mm	649906-001 and
	648925-001
320-GB, 5400-rpm, 7.0-mm	648924-001
250-GB, 7200-rpm, 7.0-mm	649902-001 and
	648911-001
250-GB, 5400-rpm, 7.0-mm	648910-001
160-GB, 7200-rpm, 7.0-mm	649901-001
Hard Drive Hardware Kit (includes bracket, cover, and screws)	656272-001
Hard Drive Cable Kit (includes hard drive connector cable)	628532-001

Before removing the hard drive, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the following components:

a.Battery (see Battery on page 40).

b.Service access cover (see Service access cover on page 43).

Remove the hard drive:

1.Lift the shield (1) that covers the hard drive connector on the system board.

2.Disconnect the hard drive connector cable (2) from the system board.

3.Remove the three Phillips 2.0×4.0 screws (3) that secure the hard drive to the computer.

4.Lift the shield (4) that covers the hard drive to allow removal of the drive.

Component replacement procedures 45