3.Remove the interior hinge covers (2).
4.Turn the computer upside down, with the front toward you.
5.Remove the rear rubber feet, and then remove the 2 Phillips 2.5×5.0 screws (1) under the feet.
6.Remove the 4 Phillips 2.0×5.0 screws (2) that secure the top cover to the base enclosure.
7.Turn the computer
8.Open the computer as far as possible.
9.Disconnect the speaker cable (1) from the system board.
10.Release the ZIF connector (2) to which the TouchPad cable is connected, and then disconnect the TouchPad cable (3) from the system board.
Component replacement procedures | 59 |