Installation
Install interface card.
9.Pull the locks on the bezel outward, then push evenly on both ends until the card engages fully and the locks swing inward to about 45°.
Figure 4. Installing Interface Card
10.Push the two locks evenly to close them, pressing downward slightly to secure them in place.
11.Remove the old card’s LED label strip in the router door from the position corresponding to the slot where you have installed the interface card, then insert the LED label strip provided with the new card as far as it will go.
12.Bend the end of the label strip toward the back of the router, creating a 90° fold.
13.Switch on the power supply by pressing the top of the switch (marked with “ ”).
14.Close the router door.
7