SOFTWARE INSTALLATION
YELLOWJACKET SOFTWARE INSTALLATION FROM A SECURE DIGITAL (SD) CARD
Yellowjacket software comes
Remember you must switch “lock” tab on side of SD card to “unlock” before storing or erasing any data.
To install the YellowJacket application from the SD card provided in the YellowJacket package, complete the following steps:
1.Insert SD card into the SD slot on the top of the iPAQ.
2.Using the stylus, tap on the “Start” button on the top of the screen.
3.Tap on “Programs” near the bottom of the menu.
4.Tap on the “File Explorer” folder.
5.Make sure that the shaded area on the top of the File Explorer says “My Device”. If not, use the
6.Tap on “SD Card”.
7.Make sure that the shaded area on the top of the File Explorer says “SD Card”. If not, use the
8.Choose your Yellowjacket receiver and iPAQ model for installation and tap on “install”.
9.When the message “Installation is Complete” appears, you have successfully installed the applica- tion.
The YellowJacket application will be accessible by tapping on “Start” and then “Programs”. Scroll down to the bottom and the YellowJacket application icon will appear.
DRIVER INSTALLATION
The 24xx model iPAQ needs an updated driver for the Quatech serial card which interfaces to your BVS product. The driver installation program can be found in the “driver” directory of your product CD. Run this executable from your PC while the iPAQ is connected via ActiveSync. After installation, soft boot the iPAQ. Your product should be ready to go. Symptoms of an iPAQ needing this driver include loss of communica- tion in a
SURVEYING
While surveying, Yellowjacket achieves the most accuracy when antenna is at a vertical 90 degree angle and completely perpendicular to the ground or floor as shown below.
Page 18