CAUTION: If the PCIe slot is not capable of providing the needed amount of power, then enabling full power draw from the PCIe slot might result in malfunction or even damage to server hardware. The user is responsible for any damage to equipment due to improper use of the override parameter. HP expressly disclaims any liability for damage arising from improper use of the override parameter. To confirm the power limits and capabilities of each slot, as well as the entire system, contact the server manufacturer. For information about using the override parameter, contact HP Customer Support.
NOTE: The override parameter overrides the setting that prevents devices from drawing more than 25 W from the PCIe slot. The parameter is enabled by device using the device serial numbers. Once the setting is overridden, each device might draw up to the full 55 W needed for peak performance.
Before you enable the override parameter, ensure that each PCIe slot is rated to provide enough power for all slots, devices, and server accessories. To determine the power slot limits, consult the server documentation, BIOS interface, setup utility, or use the
Important considerations
•If you are installing more than one dual IO Accelerator device and enabling the override parameter for each device, be sure the motherboard is rated to provide 55W power to each slot used. For example, some motherboards safely provide up to 75W to any one slot, but run into power constraints when multiple slots are used to provide that much power. Installing multiple devices in this situation might result in server hardware damage. Consult with the manufacturer to determine the total PCIe slot power available.
•The override parameter persists in the system and enables full power draw on an enabled device even if the device is removed and then placed in a different slot within the same system. If the device is placed in a slot that is not rated to provide 55W of power, your server hardware could experience a power drag.
•The override parameter is a setting for the IO Accelerator VSL software by server and is not stored in the device. When moved to a new server, the device defaults to the 25 W power limit until an external power cable is added or the override parameter is enabled for that device in the new server. To determine the total PCIe slot power available for the new server, consult the manufacturer.
Enabling the override parameter
1.Use one of the following methods to determine the serial number of each device to be installed in a compatible slot.
o Enter the
Sample output:
...
Adapter: Dual Controller Adapter
External Power: NOT connected
PCIe Power limit threshold: 24.75W Connected ioMemory modules:
Maintenance 39