SPX Cooling Technologies 160 manual Inlet Piping Plan, 4OWER $IMENSIONS Odel PER #ELL

/ Inlet Piping Plan /

L TOWER

C

E

FACE OF A DIA.
INLET FLANGE	C		D TYPICAL MULTICELL
C		C		C
L COL.		L INLET		L

F MINIMUM

FAN L TOWER

C

PIPING SHOWN WITH HIDDEN LINES IS BY OTHERS

INLET

BASE OF TOWER COL.

B DIA. FLOW CONTROL VALVE

AND CROSSOVER PIPE

L INLET

C

G

4OWER	'0-					$IMENSIONS
-ODEL	PER #ELL
		!	"	#		$	%	&			'
		θ	θ	αθ		αθ	α 6Mθ	α	6	θ	α 6 θ
		θ	θ				α 6Mθ				α 6 θ
		θ	θ	αθ		αθ	α 6Mθ	α	6	θ	α 6 θ
		θ	θ				α 6Mθ				α 6 θ
		θ	θ	αθ		αθ	α 6Mθ	α	6	θ	α 6 θ
		θ	θ				α 6Mθ				α 6 θ
		θ	θ	αθ		αθ	α 6Mθ	α	6	θ	α 6 θ
		θ	θ				α 6Mθ				α 6 θ
		θ	θ	αθ		αθ	α 6Mθ	α	6	θ	α 6 θ
		θ	θ				α 6Mθ				α 6 θ
		θ	θ	αθ		αθ	α 6Mθ	α	6	θ	α 6 θ
		θ	θ				α 6Mθ				α 6 θ
1. Use this bulletin for preliminary layouts only. Obtain current				4. Marley piping terminates at face of a cast iron flat face flange.
drawings from your Marley sales representative.					Bolt circle conforms to class 125 lb. ANSI B16.1 specifications.
2. Pumping head contributed by the tower is static lift shown				5. Supports on tower for crossover piping are furnished by Marley.
on page 7. Actual pumping head will vary according to tower					Do not support the riser’s dead load or operating load from the
circulating GPM. Total pumping head will be furnished at time of					tower. Do not brace the riser’s seismic or thrust loads against
proposal.					the tower.
3. If your application requires a bypass system, recommended				6. On Models 1611 through 1641 with a 32 or 3200 Geareducer
location is through tower endwall into plenum area. Review of					the inlet diameter must be 20″.
the system by Marley engineering is required.

10