Display assembly
NOTE: The display assembly subcomponents are spared as individual components.
Before removing the display assembly subcomponents, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 32).
5.Remove the service cover (see WLAN module on page 37).
6.Remove the rear covers (see Keyboard on page 46).
Remove the display assembly subcomponents:
1.Release the wireless antenna cables (1) from the clips (2) and routing channel built into the base enclosure.
2.Disconnect the display panel cable (3) from the system board.
3.Release the display panel cable (4) from the clip built into the base enclosure.
4.Remove the two Phillips PM2.0×5.7 screws (1) that secure the display assembly to the computer.
Component replacement procedures | 49 |