Power connector cable
Description | Spare part number |
|
|
Power connector cable (includes bracket) | |
|
|
Before removing the power connector cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 32), and then remove the following components:
a.Service cover (see WLAN module on page 37)
b.Keyboard (see Keyboard on page 46)
c.Top cover (see Top cover on page 53)
d.System board (see System board on page 58)
Remove the power connector cable:
1.Turn the system board upside down, with the right side toward you.
2.Disconnect the power connector cable (1) from the system board.
3.If necessary, separate the power connector bracket (2) from the power connector.
Reverse this procedure to install the power connector cable and bracket.
60 | Chapter 4 Removal and replacement procedures |