HP 6000, XZ930UT, VS832UT manual Enww

Page 41

7.Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until the drive snaps into place. The bottom bay is for the primary hard drive. The upper bay is for an optional secondary hard drive.

Figure 2-31Sliding a Hard Drive into the Drive Bay

8.Connect the power cable (1) and data cable (2) to the back of the hard drive. Figure 2-32Connecting the Hard Drive Cables

CAUTION: Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A sharp bend can break the internal wires.

9.If installing a new drive, connect the opposite end of the data cable to the appropriate system board connector.

NOTE: If your system has only one SATA hard drive, you must connect the hard drive data cable to the dark blue connector labeled SATA0 to avoid any hard drive performance problems. If you are adding a second hard drive, connect the data cable to the next available (unpopulated) SATA connector on the system board in the following order: SATA0, SATA1, SATA2, SATA3.

10.Route the power and data cables in their cable retainers.

11.Replace the front bezel and computer access panel.

ENWW

Installing and Removing Drives 35

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Standard Configuration Features Product Features1Front Panel Components Front Panel Components2Media Card Reader Components Media Card Reader Components3Rear Panel Components Rear Panel Components4Keyboard Components Keyboard5Windows Logo Key Functions Using the Windows Logo Key3Serial Number and Product ID Location Serial Number LocationServiceability Features Hardware Upgrades1Removing the Computer Access Panel Removing the Computer Access Panel3Tightening the Access Panel Thumbscrews Hardware Upgrades Replacing the Computer Access PanelRemoving the Front Bezel Replacing the Front Bezel Removing Bezel BlanksDDR3-SDRAM DIMMs Installing Additional MemoryDIMMs 1DIMM Socket Locations Populating Dimm SocketsInstalling DIMMs Enww 2Expansion Slot Locations Removing or Installing an Expansion Card11Removing an Expansion Slot Cover Hardware Upgrades 13Removing a PCI Express x16 Expansion Card Enww 3Drive Positions Drive Positions17Extra Guide Screw Locations Installing and Removing DrivesInstalling and Removing Drives 4System Board Drive Connections System Board Drive ConnectionsRemoving an External 5.25-inch or 3.5-inch Drive 19Disconnecting the Optical Drive Cables20Disconnecting the Media Card Reader USB Cable Enww Installing an External 5.25-inch or 3.5-inch Drive 25Connecting the Optical Drive Cables 26Connecting the Media Card Reader USB Cable Enww Removing an Internal 3.5-inch Hard Drive Enww Installing an Internal 3.5-inch Hard Drive Enww Removing and Replacing a Removable 3.5-inch Sata Hard Drive Enww 37Replacing the Hard Drive Hardware Upgrades 39Replacing the Thermal Sensor Enww Table A-1Specifications SpecificationsAppendix a Specifications Battery Replacement Type Enww Cable Lock Installing a Security LockExternal Security Devices HP Business PC Security Lock PadlockEnww Figure C-6Engaging the Lock Front Bezel SecurityEnww Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Computer Operating Guidelines and Routine Care Cleaning Optical Drive PrecautionsSafety Shipping PreparationVGA IndexEnww
Related manuals
Manual 55 pages 39 Kb
Top Page Image Contents