HP 6000, XZ930UT, VS832UT manual Type

Page 50

NOTE: On some computer models, it may be necessary to remove an internal component to gain access to the battery.

7.Depending on the type of battery holder on the system board, complete the following instructions to replace the battery.

Type 1

a.Lift the battery out of its holder.

Figure B-1Removing a Coin Cell Battery (Type 1)

b.Slide the replacement battery into position, positive side up. The battery holder automatically secures the battery in the proper position.

Type 2

a.To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1).

b.To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2).

Figure B-2Removing and Replacing a Coin Cell Battery (Type 2)

Type 3

a.Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).

44 Appendix B Battery Replacement

ENWW

Image 50

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Product Features Standard Configuration FeaturesFront Panel Components 1Front Panel ComponentsMedia Card Reader Components 2Media Card Reader ComponentsRear Panel Components 3Rear Panel ComponentsKeyboard 4Keyboard ComponentsUsing the Windows Logo Key 5Windows Logo Key FunctionsSerial Number Location 3Serial Number and Product ID LocationHardware Upgrades Serviceability FeaturesRemoving the Computer Access Panel 1Removing the Computer Access PanelReplacing the Computer Access Panel 3Tightening the Access Panel Thumbscrews Hardware UpgradesRemoving the Front Bezel Removing Bezel Blanks Replacing the Front BezelDDR3-SDRAM DIMMs Installing Additional MemoryDIMMs Populating Dimm Sockets 1DIMM Socket LocationsInstalling DIMMs Enww Removing or Installing an Expansion Card 2Expansion Slot Locations11Removing an Expansion Slot Cover Hardware Upgrades 13Removing a PCI Express x16 Expansion Card Enww Drive Positions 3Drive PositionsInstalling and Removing Drives 17Extra Guide Screw LocationsInstalling and Removing Drives System Board Drive Connections 4System Board Drive Connections19Disconnecting the Optical Drive Cables Removing an External 5.25-inch or 3.5-inch Drive20Disconnecting the Media Card Reader USB Cable Enww Installing an External 5.25-inch or 3.5-inch Drive 25Connecting the Optical Drive Cables 26Connecting the Media Card Reader USB Cable Enww Removing an Internal 3.5-inch Hard Drive Enww Installing an Internal 3.5-inch Hard Drive Enww Removing and Replacing a Removable 3.5-inch Sata Hard Drive Enww 37Replacing the Hard Drive Hardware Upgrades 39Replacing the Thermal Sensor Enww Specifications Table A-1SpecificationsAppendix a Specifications Battery Replacement Type Enww Cable Lock Installing a Security LockExternal Security Devices Padlock HP Business PC Security LockEnww Front Bezel Security Figure C-6Engaging the LockEnww Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Computer Operating Guidelines and Routine Care Safety Optical Drive PrecautionsCleaning Shipping PreparationIndex VGAEnww

Related manuals

Manual 55 pages 39 Kb