Configure the print server using the HP Embedded Web Server
You can now configure the HP Jetdirect 2700w Print Server by using the HP Embedded Web Server. This is done by accessing the IP address of the printer/MFP in which the print server is installed. The printer/MFP must be directly connected (wired) to your local network.
Use the following steps to configure the HP Jetdirect 2700w Print Server:
1.Start a supported Web browser from a computer that is connected to your intranet.
2.Enter the IP address of the printer/MFP as the URL. For example: http://nnn.nnn.nnn.nnn/
NOTE: You can typically locate the IP address by using the printer/MFP control panel or by printing a configuration page.
The HP Embedded Web Server is displayed.
3.Select the Networking tab.
4.From the Configuration menu, select Wireless.
The Wireless page displays all the wireless configuration parameters required to make a wireless connection to your network.
5.To use a wizard, which will guide you through the required 802.11 wireless configuration parameters, click Wireless Wizard in the General section. Remember to click Apply to save your settings.
6.Otherwise, enter the information needed to make a wireless connection to your network.
7.Click Apply to set, or Cancel to ignore your entries. To resent to
6 | Chapter 2 Installation | ENWW |