HP Virtual Connect Manager 1.16 manual Resolved issues

Page 13

•When running with 16:1 oversubscription ratio on a VC-FC module, the hardware registers do not allow auto-routed traffic for the sixteenth server blade. When this scenario occurs, the firmware routes FC frames, causing a significant drop in the performance.

The following issues that existed in Virtual Connect 1.15b and earlier versions have been resolved in Virtual Connect 1.16:

•Server profiles could be assigned to a bay occupied by a non-server device.

•The Virtual Connect GUI labeled all server bays as Bay 0 and failed to recognize any servers in the enclosure.

•Signal quality for 10GBASE-CX4 cables was poor.

Resolved issues 13

Page 12 Page 13
Image 13
Page 12 Page 13
Contents Part Number October 2007 First Edition Audience assumptions Contents HP Virtual Connect Manager firmware Hardware and firmware requirementsSupported hardware Required firmware versions for this release Firmware upgrade requirementsHP Virtual Connect Fibre Channel Module Compatibility Matrix New features Important notes and recommendations Important notes and recommendations Fibre Channel and SAN boot Known issues General User interface Firmware updateResolved issues Resolved issues
Top Page Image Contents