HP z560, z565 Lithium Battery Caution Laser Safety Statement, TV Antenna Connectors Protection

Page 15

WARNING: Your PC is provided with a voltage select switch for use in a 115 or 230 V￿ power system. The voltage select switch has been pre- set to the correct voltage setting for use in the particular country/region where it was initially sold. Changing the voltage select switch to the incorrect position can damage your PC and void any implied warranty.

WARNING: To reduce the possibility of an electric shock from the telephone network, plug your computer into the AC outlet before connecting it to the telephone line. Also, disconnect the telephone line before unplugging your computer from the AC power outlet.

WARNING: Always disconnect the modem cord from the telephone system before installing or removing your computer cover.

WARNING: Do not operate the computer with the cover removed.

WARNING: For your safety, always unplug the PC from its power source and from any telecommunications systems (such as telephone lines), networks, or modems before performing any service procedures. Failure to do so may result in personal injury or equipment damage. Hazardous voltage levels are inside the power supply and modem of this product.

Lithium Battery Caution

WARNING: The PC uses a lithium battery, type CR2032. There is danger of an explosion if the battery is incorrectly replaced. Replace only with the same, or equivalent, type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

Laser Safety Statement

Class 1 LED Product

The CD and DVD drives contain a laser system and are classified as a “Class 1 Laser Product” under a U.S. Department of Health and Human Services (DHHS) Radiation Performance standard according to the Radiation Control for Health and Safety Act of 1968.

Should the unit ever require maintenance, contact an authorized service location.

WARNING: Use of controls, adjustments, or performance procedures other than those specified in the Upgrading and Servicing Guide may result in hazardous radiation exposure. To prevent direct exposure to laser beam, do not try to open the enclosure of the CD or DVD drives.

Laser Product Label

The following label or equivalent is located on the surface of laser products:

This label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label appears on a laser device installed in your product.

Note to CATV System Installer

This reminder is provided to call the CATV systems installer’s attention to section 820-93 of the National Electric Code, which provides guidelines for proper grounding and in particular, specify that the Coaxial cable shield shall be connected to grounding system of the building, as close to the point of cable entry as practical.

TV Antenna Connectors Protection

External Television Antenna Grounding

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is electrically grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper electrical grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Lightning Protection

For added protection of any product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug the product from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product from lightning and power line surges.

13

Image 15
Contents Page Page Table of Contents General Terms Hardware Limited WarrantyExclusions Exclusive RemedyLimitation of Liability Types of Warranty Service Limited Warranty PeriodService Upgrades Options and Software Limited WarrantiesTechSupport/Document.jsp?objectID=lpg50101 End-User License Agreement Software Technical SupportContacting HP Transfer Page Declaration of Conformity Regulatory and Safety Information Operating SpecificationsStatement of Fax Branding Consumer Information and FCC RequirementsCanada Department of Communications DOC Notice AC Power Safety WarningLaser Product Label Lithium Battery Caution Laser Safety StatementTV Antenna Connectors Protection Class 1 LED ProductSupport Information Don’t Forget to RegisterGo to http//register.hp.com HP Total Care Where to Get HelpOptions to use when you need help Software SupportWhen Should I Contact HP Total Care Support Services? If Necessary Get RepairProtect Your Investment Recovering from Software Problems To start System Restore System RestoreApplication Recovery and Driver Recovery System RecoveryTo create System Recovery discs Creating System Recovery DiscsStarting System Recovery if the DEC is responding Creating a Recovery Tools CDRunning System Recovery from the Hard Disk Drive To create or start the Recovery Tools CDTo run the System Recovery program using recovery discs Running System Recovery from Recovery DiscsPrinted
Related manuals
Manual 138 pages 17.55 Kb Manual 20 pages 52.41 Kb Manual 36 pages 36.18 Kb