HP M517, M417 manual Not Enough

Message	Possible Cause	Solution
NOT ENOUGH	The light is low	Add light to the scene.
LIGHT FOR FAST	and the image is	(Flash is set to Flash Off in
SHOT	likely to be noisy	Fast Shot mode.)
	due to the small
	aperture setting
	used in Fast Shot
	mode.
	The light is low	Use the flash (see
	and the image is	page 40), set the camera
(camera shake	likely to be blurry	on a stable surface, or use
warning)	due to the long	a tripod.
	exposure
	required.
ERROR SAVING	The optional	• Always wait until the
IMAGE	memory card that	Memory light stops
or	is installed was	blinking before
ERROR SAVING	half-locked or	removing the memory
VIDEO	was removed	card from the camera.
	before the	• With the camera
	camera finished	turned off, remove the
	writing to the	memory card and
	card.	check to see if the
		locking tab on the
		edge of the card is fully
		in the unlocked
		position.

Troubleshooting and Support 127