HP SR5050NX, a1712n, a1709n, a1700n, a1767c, a1530a, a1520e Miscellaneous, Symptom Possible solution

Miscellaneous

Symptom	Possible solution
Insufficient memory message	Close all open programs, and then try the desired task
displays.	again, or restart your computer (click the Windows Start
	Button, click the Arrow button next to the Lock button,
	and then click Restart). If the message displays again,
	consider purchasing and installing additional memory.
Remote sensor is not receiving	1 Click the Windows Start Button, right-click Computer, and then
a signal from the remote	select Properties.
control (select models only).	2 Under Tasks, click Device Manager.
	3 Click the plus (+) sign next to Universal Serial Bus Controllers.
	4 If the eHome Infrared Receiver is listed under Universal Serial Bus
	Controllers, Windows Vista is properly detecting the IR Receiver. If it is not
	listed, go to the next step.
	5 Unplug the end of the USB cable on the remote sensor from the computer
	and plug it into the same USB port.
	6 Disconnect all other USB devices, leave the remote sensor plugged in, and
	then restart the computer. Plug in other USB devices after the remote sensor
	appears in the Device Manager window.
Memory card reader (select	Do not insert or remove memory cards when the in-use light is flashing. To do
models only) cannot read my	so may cause data loss, or it may permanently damage the card reader.
memory card.
	Some cards have a Read/Write or Security switch on the card. Make sure the
	switch is set to Write Enabled before attempting to write data to it.
	Make sure the amount of data you are storing has not exceeded the storage
	limit of the card.
	Make sure the memory card is one of the supported types: CompactFlash (I, II,
	and Microdrive), Memory Stick, Memory Stick Pro, MultiMedia, Secure
	Digital, SmartMedia, or xD. Some models may support additional types.
	Make sure the memory card is fully inserted into the correct slot.
	Inspect the ends of the memory cards for dirt or material closing a hole or
	spoiling a metal contact. Clean the contacts with a lint-free cloth and small
	amounts of isopropyl alcohol. Replace the memory card if necessary.

20Troubleshooting and Maintenance Guide