BEFORE OPERATION
REMOTE CONTROL PREPARATION
Replacing Batteries
1Remove the cover of the | 2 Remove the used batteries and |
battery compartment at the | insert new batteries. The remote |
back of the remote control by | control uses two alkaline batteries. |
sliding it out in the direction of | (1.5V, LR03x2) |
the arrow. |
|
OWNER,S MANUAL
3 Press the RST button with a sharp object to reset the remote control .
ON/OFFSLEEP
TEMP.
RST | TA |
LR03(AM4)1.5V |
|
LR03(AM4)1.5V |
|
RST TA |
LR03(AM4)1.5V
LR03(AM4)1.5V
MODE |
| FAN | FLAP |
CLOCK |
| HOUR | MINUTE |
TIMER | RESERV. CANCEL | ||
ON | OFF | ||
RST | TA |
|
|
NOTE
•Do not fit use the used batteries or batteries of a different type. Such use may cause the unit to malfunction.
•Changing batteries should be done after turning off the unit.
•The average battery life during normal use is approximately one year.
•When the air conditioner does not operate normally after replacing the batteries, remove the batteries, refit them and repress the RST button after 5 seconds.
•TA/RST button may locate back side near battery compartment for some models.
Setting Current Time
4 Press the TA button with a sharp | 5 Set the current time with the hour | ||
object and the current time | and the minute buttons while the | ||
indication symbol flashes. In the | current time indication flashes. | ||
beginning, 6:00A.M. will flash. |
|
| |
ON/OFF | SLEEP | ON/OFF | SLEEP |
|
| ||
TEMP.
TEMP.
|
|
| MODE |
| FAN | FLAP |
MODE |
| FAN | FLAP |
|
|
|
|
|
| CLOCK | EVERYDAY HOUR | MINUTE | |
CLOCK | EVERYDAY |
| MINUTE |
|
|
|
TIMER |
| TIMER | RESERV. CANCEL | |||
| ON | OFF | ||||
ON | OFF | RESERV. CANCEL |
|
|
| |
RST | TA |
| RST | TA |
|
|
|
|
|
|
| ||
6 Press the TA button again. The flashing will stop and the current time will be set.
ON/OFFSLEEP
TEMP.
MODE |
| FAN | FLAP |
CLOCK | EVERYDAY |
| MINUTE |
TIMER | RESERV. CANCEL | ||
ON | OFF | ||
RST | TA |
|
|
Matching Address between Indoor Unit and Remote Control
1 When two units are used in the same room, you can match the address of the remote control to that of the unit.
2 Remove the lid of the battery case. Assign the address switch of one remote control as B. Press the RST button with a sharp object.
Turn off the unit and pull out the power plug. Remove the front panel, Terminal block cover, and Frame grille.
3 Pull out the PCB. Assign the address switch of one indoor unit as B.
NOTE
•This function must only be performed by qualified service personnel.