2Press inward on each side of the bracket brace (3), and lower the bracket until it snaps into place over the diskette drive. Ensure that the guide screws (4) are installed in the adapter.
3Return to “replacing or adding a drive” on page 5, and begin with step 1.
3
| 2 |
2 | 1 |
|
4 |
2
replacing the diskette drive adapter on the 8000 series
upgrading or replacing memory
Your PC comes with random access memory (RAM), which temporarily stores data and instructions on your PC. You can install memory expansion modules in the memory expansion slots in the PC. The procedures for upgrading or replacing these modules are the same for the S0000 and 8000 series.
removing a memory module
CAUTION: When handling a memory module, be careful not to touch any of the contacts. Doing so may damage the module.
1Complete the procedure described in “preparing the pc” on page 1, but do not remove the front bezel.
2Locate the memory module inside your PC. See the following illustration for the location of the memory modules (1), memory slots (2), and release latches
(3) on the system board.
locating the memory module
NOTE: The location and number of memory modules may vary slightly by model.
3Open both latches of the memory module socket
(1) found at each end of the memory module. Lift the memory module (2) from the memory slot.
removing a memory module
Upgrading and Servicing Guide 7