NOTE: If you have the S0000 series, and you removed a
If you have the 8000 series and you removed a hard disk drive, a
6For an 8000 series diskette drive, squeeze inward on both sides of the bracket brace and lift the brace up and out (1). Remove the two sets of screws (2) (left and right sides) that secure the drive to the drive adapter. Lift the diskette drive out of the drive adapter (3) by sliding the drive back and then up. Ensure that the guide screws (4) (left and right sides) are left in the drive adapter. You are finished with the task of removing the drive.
1
2 | 3 |
|
2
4 |
2
removing a diskette drive from the drive adapter on the 8000 series
7For the S0000 series
removing a
replacing or adding a drive
The steps to replace or add a drive are the same for both the S0000 and 8000 series, except when you are replacing a diskette drive on the 8000 series, or the
If you are replacing a diskette drive on the 8000 series, before starting step 1 in the following instructions, you need to fit the diskette drive in a diskette drive adapter as described in “reassembling the diskette adapter” on page 6.
If you are replacing a
If you are replacing or adding any other drive, begin with step 1 in the following instructions.
to replace or add a drive
1Install four guide screws on the sides of the drive (two on each side). The screws help guide the drive into its proper position in the bay.
•When replacing a drive on the S0000 and 8000 series, place the screws that you removed from the old drive in the new drive.
•When adding a second hard disk drive on the 8000 series, use the four extra guide screws that are attached to the chassis under the front bezel.
Upgrading and Servicing Guide 5