HP S7300CL manual Reassembling the pc

•If you have an 8000 series, continue to step 2.

•If you have an S0000 series, skip to step 3.

2For the 8000 series, secure the expansion card to the chassis with the slot cover screw.

3For both the S0000 and 8000 series, if you have replaced an expansion card, store the old card in the anti-static packaging that contained your new card.

•If you have an S0000 series, continue to step 4.

•If you have an 8000 series, skip to step 5.

4For the S0000 series, replace the expansion cover bracket (1) and screw (2).

replacing the expansion bracket cover on the S0000 series

5For both the S0000 and 8000 series, complete the procedure described in “reassembling the pc” on page 10.

reassembling the pc

1Replace the front bezel by following the method appropriate for your PC model.

•To replace the front bezel on the S0000 series, position the chassis in the upright position. At an angle, align the top of the front bezel with the top slots of the chassis (1) so that the front bezel hooks onto the chassis, and then press the bottom end of the bezel to the chassis until it snaps into place (2).

10Upgrading and Servicing Guide

1

2

replacing the front bezel on the S0000 series

•To replace the front bezel on the 8000 series, lay the chassis on the side with the open side up. Place the front bezel in the correct position. Ensure the slots (2) are aligned correctly, and rotate the bezel toward the chassis (1) until it snaps into place.

replacing the front bezel on the 8000 series

2For either the S0000 or 8000 series, place the side access panel in the proper position on the chassis and slide it into place (1). Ensure that the hole for the thumbscrew(s) align with the hole in the chassis (2), and replace the thumbscrew(s).