HP S3905F manual Replacing a PCI Card

Replacing a PCI Card

IMPORTANT: Due to the small computer size, you can only install a small, low-profile PCI card of the same approximate size of the modem card. HP recommends that you install a card with power consumption of 5 watts or less.

Not all low-profile cards will fit into the PCI slot. Some external connectors, especially connectors located at the top of the card, may not fit properly into the back panel.

You can replace the modem card with a new modem card or another PCI card in the PCI card slot:

1 Complete the procedures to remove the modem card. See “Removing a PCI Card” on page 20.

2 Align the edge of the add-in card with the slot on the computer, and gently but firmly press the card straight down into the card slot. The whole connector should be seated properly in the card slot.

3 Attach the bracket holder with the screw to secure the card.

4 Connect any internal cables attached to the card.

5 Complete the procedures to close the computer. See “Closing the Computer” on page 7.

6 Install any software drivers — supplied by the card manufacturer if you are installing another PCI card — or as required.

NOTE: If the new card or device isn’t working, read the card manufacturer’s installation instructions, and recheck all connections, including those to the card, power supply, keyboard, and monitor.

Upgrading and Servicing Guide 21