HP D510 manual Replacing a Coin Cell Battery Type

Page 54

Battery Replacement

c.To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery.

Replacing a Coin Cell Battery (Type 2)

✎After the battery has been replaced, use the following steps to complete this procedure.

5.Replace the computer cover or access panel.

6.Plug in the computer and turn on power to the computer.

7.Reset the date and time, your passwords, and any special system setups, using Compaq Computer Setup. Refer to the Computer Setup (F10) Utility Guide.

If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable the Smart Cover Sensor.

C–4	Hardware Reference Guide

Image 54

Contents Hardware Reference Guide Page Contents Specifications Hard Drive Installation Guidelines Index Product Features Standard Configuration FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsEasy Access Keyboard Components Easy Access Keyboard ComponentsCustomizing the Easy Access Buttons Using the Windows Logo Key Special Mouse FunctionsSerial Number Location Hardware Upgrades Installation SequenceDrawer Installation Method Using the Smart Cover FailSafe Key Smart Cover LockRemoving the Smart Cover Lock Screws Removing the Computer Cover Removing the Computer Cover Installing Additional Memory DIMMsDDR-SDRAM DIMMs Installing DDR-SDRAM DIMMs Locate the memory module sockets Installing a Dimm Removing the Expansion Card Cage Installing an Expansion Card Removing the Expansion Slot Cover Install the expansion card Removing the AGP Card To replace the AGP card, reverse the above procedures Drive Positions Desktop Drive PositionsInstalling Additional Drives Upgrading the Hard DriveDisconnecting Cables from the Hard Drive Removing an Optical Drive Removing the Optical Drive Installing an Optional Optical Drive Connecting the Flat Ribbon Cable and Audio Cable Working with the MultiBay Hot-Plugging or Hot-Swapping MultiBay Drives Partitioning and Formatting a MultiBay Hard DriveUninstalling the MultiBay Security Screw Inserting a Drive into the MultiBayRemoving a Drive from the MultiBay Removing a Drive from the MultiBay Specifications Compaq Evo Small Form FactorPower Output Hard Drive Installation Guidelines Using the Cable-Select Feature with Ultra ATA DevicesGuidelines for Installing Ultra ATA Devices Guidelines for Using Scsi Devices Scsi DevicesHard Drive Installation Guidelines Guidelines for Installing Optional Scsi Devices Scsi ControllersUsing a Scsi Cable Using SCSISelect with Scsi DevicesScsi Cables Choosing the Quiet Drive Options Hard Drive Installation Guidelines Battery Replacement Type Type Replacing a Coin Cell Battery Type Installing a Security Lock Security Lock ProvisionsInstalling a Security Loop Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Electrostatic Discharge Routine Computer Care Shipping Preparation Routine Computer CareSafety Optical Drive PrecautionsCleaning OperationShipping Preparation Index Index-2

Related manuals

Manual 27 pages 54.23 Kb