HP dc7600 manual Type

Page 59

Battery Replacement

Type 3

a.Pull back on the clip 1 that is holding the battery in place, and remove the battery 2.

b.Insert the new battery and position the clip back into place.

Removing a Coin Cell Battery (Type 3)

✎After the battery has been replaced, use the following steps to complete this procedure.

5.Replace the computer cover.

6.Plug in the computer and turn on power to the computer.

7.Reset the date and time, your passwords, and any special system setups, using Computer Setup. Refer to the Computer Setup (F10) Utility Guide on the Documentation and Diagnostics CD.

8.If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable the Smart Cover Sensor.

B-4

www.hp.com

Hardware Reference Guide

Image 59

Contents Hardware Reference Guide Hardware Reference Guide Contents Index Standard Configuration Features Product FeaturesFront Panel Components Front Panel ComponentsRear Panel Components Rear Panel ComponentsKeyboard Components KeyboardWindows Logo Key Special Mouse FunctionsSerial Number Location Serviceability Features Hardware UpgradesUsing the Small Form Factor Computer in a Tower Orientation Unlocking the Smart Cover Lock Using the Smart Cover FailSafe KeyRemoving the Smart Cover Lock Screw Removing the Computer Cover Replacing the Computer Cover DDR2-SDRAM DIMMs Installing Additional MemoryDIMMs Populating Dimm Sockets Description Socket Color Installing DIMMs Installing a Dimm Hardware Upgrades Installing an Expansion Card Removing the Expansion Slot Cover Installing an Expansion Card Hardware Upgrades Removing a PCI Express x16 Expansion Card Hardware Upgrades Installing Additional Drives Drive Positions Locating Drive PositionsRemoving an Optical Drive Disconnecting the Power and Data Cables Rotate the drive cage back down to its normal position Removing the Optical Drive Removing a Diskette Drive Disengaging the Diskette Drive Removing the Diskette Drive Installing an Optional Optical Drive Installing the Optical Drive Rotate the drive cage to its upright position Connecting the Power and Data Cables Rotate the drive cage back down to its normal position Removing and Replacing the Primary Hard Drive Upgrading the Sata Hard DriveRotating the Drive Cage Up Removing the Security Clip Raising the Power Supply Cage Disconnecting the Hard Drive Power Cable and Data Cable Removing the Hard Drive Installing an Optional Drive into the 3.5-inch Drive Bay Hardware Upgrades Hardware Upgrades Removing a Drive Bezel Diskette Drive Bezel shown Installing a Drive Bezel Bezel Blank for Hard Drive shown HP Compaq Small Form Factor SpecificationsPower Output Battery Replacement Type Removing and Replacing a Coin Cell Battery Type Type Cable Lock Installing a Security LockSecurity Lock Provisions Padlock Without Security Cable Universal Chassis Clamp LockSecurity Lock Provisions With Security Cable Security Lock Provisions Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Electrostatic Discharge Computer Operating Guidelines and Routine Care Operation Optical Drive PrecautionsCleaning SafetyShipping Preparation Index Index Index-3

Related manuals

Manual 26 pages 40.74 Kb

Manual 66 pages 17.44 Kb