HP dc7600 manual Upgrading the Hard Drive

Page 34

Hardware Upgrades

10.Replace the access panel.

11.Install the optional cable lock, if desired.

12.Replace the stand, if desired.

13.Reconnect all external devices, plug the power cord into the power outlet, and turn the computer on.

14.Use Computer Setup to enable the Smart Cover Sensor, if desired.

Upgrading the Hard Drive

✎The Ultra-Slim Desktop supports only Serial ATA (SATA) internal hard drives; parallel ATA (PATA) internal hard drives are not supported.

Be sure to back up the data from the old hard drive before removing it so that you can transfer the data to the new hard drive.

The 3.5-inch hard drive is located on the left side of the computer, under the MultiBay.

1.If the Smart Cover Sensor is enabled, restart the computer and enter Computer Setup to disable it.

2.Turn off the computer properly through the operating system, then turn off any external devices.

3.Disconnect the power cord from the power outlet and the computer, and disconnect any external devices.

4.Position the computer on its side with the rubber pads on the bottom. (If the computer is being used in the tower configuration, remove the computer from the stand. Refer to “Attaching and Removing the Tower Stand” on page 2–7for more information.)

5.Remove the access panel. Refer to “Removing and Replacing the Access Panel” on page 2–1for more information.

6.Remove the front bezel and MultiBay. Refer to “Removing and Replacing the Front Bezel and MultiBay” on page 2–3for more information.

2–24

www.hp.com

Hardware Reference Guide

Image 34

Contents Hardware Reference Guide Hardware Reference Guide Contents Index Product Features Standard Configuration FeaturesFront Panel Components Rear Panel Components Standard Keyboard Components Lock, and Scroll LockWindows Logo Key Choose Tower or Desktop Configuration Serial Number and Product ID LocationHardware Upgrades Removing and Replacing the Access PanelRemoving the Access Panel Removing and Replacing the Front Bezel and MultiBay Removing the MultiBay Daughter Card Disconnect the fan cable Removing the Front Bezel and MultiBay Attaching and Removing the Tower Stand Attaching the Stand to the Computer Removing the Stand from the Computer Rotating the Computer into the Desktop Position DIMMs Installing Additional MemoryDDR2-SDRAM DIMMs Dimm Sockets Description Socket Color Adding or Removing a Memory Module Removing Memory Modules Adding Memory Modules Adding or Removing an Expansion Card Installing an Expansion Card Removing an Expansion Card Slot Cover Installing an Expansion Card Installing the Expansion Card Assembly Removing an Expansion Card Removing an Expansion Card Upgrading the Hard Drive Removing the Internal Hard Drive Hardware Upgrades Data 1 and Power 2 Cable Connector Locations Working with the MultiBay Hot-Plugging or Hot-Swapping MultiBay Drives Engaging and Releasing the MultiBay Security CatchEngaging the MultiBay Security Catch Releasing the MultiBay Security Catch Removing a Drive from the MultiBay Inserting a Drive into the MultiBay Partitioning and Formatting a MultiBay Hard Drive Specifications Ultra-Slim DesktopPower Output Battery Replacement Removing the Power Supply Replacing the Battery Battery Replacement Security Provisions Installing an Optional Security LockCable Lock Padlock Universal Chassis Clamp Lock Without Security CableSecurity Provisions With Security Cable Security Provisions Preventing Electrostatic Damage Electrostatic DischargeGrounding Methods Electrostatic Discharge Computer Operating Guidelines and Routine Care Safety Optical Drive PrecautionsCleaning OperationShipping Preparation Page Index Index Index-3

Related manuals

Manual 26 pages 40.74 Kb

Manual 73 pages 14.36 Kb