HP dc5750 manual Enww

Page 47

NOTE If the system has only one SATA hard drive, the data cable must be connected to the dark blue connector labeled SATA0 on the system board to avoid any hard drive performance problems. If you are adding a second hard drive, connect the other end of the data cable to the next available (unpopulated) SATA connector on the system board in the following order: SATA0, SATA1, SATA3, SATA2.

When replacing the hard drive, transfer the four screws from the old drive to the new one. You will need a Torx T-15 screwdriver to remove and re-install the guide screws. HP has provided four extra 6-32 standard guide screws on the front of the chassis, under the front bezel. The 6-32 standard guide screws are silver.

If you replaced the primary hard drive, use the Restore Plus! CD set that you created when you initially set up the computer to restore the operating system, software drivers, and any software applications that were preinstalled on the computer. When the restore process has completed, reinstall any personal files that you backed up before replacing the hard drive.

ENWW	Installing and Removing Drives 41

Image 47

Contents Hardware Reference Guide dc5750 Small Form Factor Model Hardware Reference Guide About This Book Iv About This Book Table of contents Appendix D Electrostatic Discharge Standard Configuration Features Product FeaturesFront Panel Components Drive configuration may vary by model2Rear Panel Components Rear Panel Components3Keyboard Components KeyboardUsing the Windows Logo Key Serial Number Location Special Mouse FunctionsServiceability Features Hardware UpgradesUsing the Small Form Factor Computer in a Tower Orientation Using the Small Form Factor Computer in a Tower Orientation 2Removing the Computer Access Panel Hardware Upgrades Removing the Computer Access Panel3Replacing the Computer Access Panel Replacing the Computer Access PanelRemoving the Front Bezel 4Removing the Front Bezel Hardware Upgrades5Removing a Bezel Blank Replace the front bezel Removing Bezel BlanksReplacing the Front Bezel 6Replacing the Front Bezel Hardware UpgradesDDR2-SDRAM DIMMs Installing Additional MemoryDIMMs Description Socket Color Populating Dimm SocketsInstalling DIMMs 9Rotating Optical Drive Retainer Up Hardware Upgrades Enww Description Removing or Installing an Expansion Card12Removing the Expansion Slot Retainer 13Removing an Expansion Slot Cover Hardware Upgrades 15Removing a PCI Express x16 Expansion Card 16Installing an Expansion Card Hardware Upgrades Replace the slot cover retainer 18Drive Positions Drive PositionsInstalling and Removing Drives Removing an Optical Drive 20Removing the Optical Drive 22Installing the Optical Drive Hardware Upgrades Enww Removing a Diskette Drive 24Disconnecting the Diskette Drive Cables Hardware Upgrades26Removing the Diskette Drive Enww 29Installing a Diskette Drive Enww Enww 32Disengaging the Diskette Drive Hardware Upgrades 34Disconnecting the Hard Drive Power Cable and Data Cable Enww Enww Enww Power Supply 115V 230V SpecificationsRated Input Current maximum1 Battery Replacement Type Figure B-2Removing and Replacing a Coin Cell Battery Type Enww Cable Lock Installing a Security LockExternal Security Devices Padlock Grounding Methods Electrostatic DischargePreventing Electrostatic Damage Appendix D Electrostatic Discharge Computer Operating Guidelines and Routine Care Shipping Preparation Optical Drive PrecautionsCleaning SafetyIndex Enww

Related manuals

Manual 52 pages 58.36 Kb

Manual 72 pages 24 Kb