Replacing an Optical Disc Drive
IMPORTANT: The new (replacement) part may not look the same as the original part, due to different manufacturers or models.
1Insert the drive partway into the computer bay.
2Connect the data (1) and power (2) cables to the back of the drive.
4Push the drive completely into the computer, until the optical drive latch locks it into place in the hole labeled 2 on the computer.
5Hold the front panel over the computer, and then press the left side of the panel, inserting the tabs into the computer. Swing the right side of the panel toward the computer, and then press it into the computer.
2 1
3Pull out the optical drive latch (1), swing it to the right (2), and release it into the hole labeled 2 on the computer.
1
2
6Hold the side panel over the side of the computer with the front edge of the panel about 2.5 cm (1 inch) from the front of the computer.
6 |
|