HP 402 G1 manual

Page 18

6.Disconnect the power cable and data cable from the rear of the optical disc drive.

CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid damaging the cable.

7.Unfasten the screw securing the optical disc drive cage to the chassis.

Retain the screw.

8.Press the both sides optical disk drive latch to release the optical disc drive cage and slide the cage away from the edge of the chassis.

9.Lift the optical disc drive cage out of the chassis.

12 Chapter 2 Hardware upgrades

Image 18

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Cleaning Safety Shipping preparation Product features Standard configuration featuresFront panel components Rear panel components Serial number locationHardware upgrades Serviceability featuresRemoving the computer access panel Replacing the computer access panel Changing from desktop to tower configurationDDR3-SDRAM DIMMs Installing additional memoryDIMMs Populating Dimm socketsInstalling DIMMs Page Removing or installing an expansion card Page Installing and removing drives Removing a slim optical disc drivePage Page Installing a slim optical disc drive Page Removing and replacing a 3.5-inch hard drive Page Page Page Page Installing a security lock Cable lockPadlock Battery replacement TypeType Page Electrostatic discharge Preventing electrostatic damageGrounding methods Computer operating guidelines and routine care Safety Optical disc drive precautionsCleaning Shipping preparationIndex Locks

Related manuals

Manual 120 pages 21.06 Kb