HP 402 G1 manual

Page 30

b.Insert the new battery and position the clip back into place.

NOTE: After the battery has been replaced, use the following steps to complete this procedure.

8.Replace the computer access panel.

9.Plug in the computer and turn on power to the computer.

10.Reset the date and time, your passwords, and any special system setups using Computer Setup.

11.Lock any security devices that were disengaged when the computer access panel was removed.

24 Appendix A Battery replacement

Image 30

Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Cleaning Safety Shipping preparation Product features Standard configuration featuresFront panel components Rear panel components Serial number locationHardware upgrades Serviceability featuresRemoving the computer access panel Replacing the computer access panel Changing from desktop to tower configurationDDR3-SDRAM DIMMs Installing additional memoryDIMMs Populating Dimm socketsInstalling DIMMs Page Removing or installing an expansion card Page Installing and removing drives Removing a slim optical disc drivePage Page Installing a slim optical disc drive Page Removing and replacing a 3.5-inch hard drive Page Page Page Page Installing a security lock Cable lockPadlock Battery replacement TypeType Page Electrostatic discharge Preventing electrostatic damageGrounding methods Computer operating guidelines and routine care Safety Optical disc drive precautionsCleaning Shipping preparationIndex Locks

Related manuals

Manual 120 pages 21.06 Kb