HP 402 G1 manual

Page 24

11.Remove the two screws from the side of the hard drive cage, and then slide the hard drive out of the cage.

Retain the screws to use on the new hard drive.

12.Slide the new hard drive all the way into the hard drive cage.

Be sure the hard drive is positioned properly. The latch tab that secured the hard drive cage to the chassis is on the bottom side of the drive cage. The bottom of the hard drive should be on the same side as the tab and the connectors should be visible on the opposite end from the tab.

13.Close the latch on the side of the hard drive cage.

Be sure the latch is engaged by attempting to move the hard drive within the cage. If it moves, slide the hard drive to and from the end of the cage until the latch engages.

14.Fasten the two screws in the other side of the hard drive cage to secure the hard drive in the cage.

18 Chapter 2 Hardware upgrades

Image 24
Contents Hardware Reference Guide Hardware Reference Guide About This Book Iv About This Book Table of contents Cleaning Safety Shipping preparation Product features Standard configuration featuresFront panel components Rear panel components Serial number locationHardware upgrades Serviceability featuresRemoving the computer access panel Replacing the computer access panel Changing from desktop to tower configurationInstalling additional memory DIMMsDDR3-SDRAM DIMMs Populating Dimm socketsInstalling DIMMs Page Removing or installing an expansion card Page Installing and removing drives Removing a slim optical disc drivePage Page Installing a slim optical disc drive Page Removing and replacing a 3.5-inch hard drive Page Page Page Page Installing a security lock Cable lockPadlock Battery replacement TypeType Page Electrostatic discharge Preventing electrostatic damageGrounding methods Computer operating guidelines and routine care Optical disc drive precautions CleaningSafety Shipping preparationIndex Locks
Related manuals
Manual 120 pages 21.06 Kb