Verify Ethernet connectivity

3.Observe whether the ioscan output reports the following: lan 0/3/0/0/0/0 UNCLAIMED UNKNOWN

If reported, HP-UX detected the adapter but the iocxgbe driver is not recognized.

4.If the correct driver is installed and the adapter is not listed in the ioscan output, contact HP for assistance.

Once the HP Ethernet software and hardware are installed and running, use the following steps to verify connectivity:

1.Check the state of all Ethernet hardware and interfaces. Enter the ioscan -kfnC lan command and verify the S/W State is CLAIMED.

If the Ethernet device file has not been created, enter the following commands:

#insf -e

#ioscan -f

2.Verify link-level connectivity with a remote system on the network you have attached to the Ethernet adapter by using the nwmgr command in the following format.

nwmgr --diag -A dest=destination_MAC_address -c lanppa

NOTE: When you use nwmgr --diagto check connectivity, ensure that the remote system is on the same subnet and is an HP-UX-based system.

Alternate website for downloading files

1.See the following HP website: http://www.hp.com/#Support

2.You can click open the Support & Drivers link or enter your adapter product number in the SEARCH HP.COM field, then click go. For example, type AT094A.

3.At the next web page, either locate the Software & driver downloads link to continue search or view the returned listing for your selected product.

4.Download the drivers, firmware, or documentation as needed.

Verify Ethernet connectivity