HP LV1561w, LV1561WS, CQ1569 manual Mounting the Monitor

Page 13

CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a prolonged period of time. To avoid burn-in image damage on your monitor screen, you should always activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. Image retention is a condition that may occur on all LCD screens.

Mounting the Monitor

You can remove the monitor base to mount the monitor on a wall, a swing arm, or other mounting fixture.

Four threaded mounting holes are provided on the monitor back panel to be used for mounting purposes. These mounting holes are 75mm apart and are compliant with the Video Electronics Standards Association (VESA) standard for mounting flat panel displays.

CAUTION: This monitor supports the VESA industry standard 75 mm mounting holes. To attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer screws should not be used because they may damage the monitor. It is important to verify that the manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cables provided with the monitor.

1.Disconnect and remove the signal and power cables from the back of the monitor.

2.Lay the monitor face down on a flat surface.

CAUTION: Do not remove the base from the monitor while the monitor is in the upright position. Lay the front bezel down on a soft area to prevent it from getting scratched, defaced, or broken. Ensure that the bottom of the monitor base is positioned over a table or desktop before removing the base from the monitor.

3.Remove the pedestal base as shown in the following illustration.

4.Place the mounting fixture onto the back of the monitor. Line up the holes on the mounting fixture with the holes in the back of the monitor.

5.Insert four screws into the holes and tighten.

6.Reconnect the cables.

ENWW

Mounting the Monitor 7

Page 12 Page 14
Image 13
Page 12 Page 14
Contents HP LV1561w, LV1561ws, and CQ1569 LCD Monitors Page About This Guide Iv About This Guide Table of contents Appendix D LCD Monitor Quality and Pixel Policy HP LCD Monitors Product FeaturesImportant Safety Information Safety and Maintenance GuidelinesCleaning the Monitor Maintenance GuidelinesShipping the Monitor Installing the Monitor Base Setting Up the MonitorComponent Function Identifying Rear ComponentsConnecting the Cables Mounting the Monitor 4Removing the Monitor Base Setting Up the Monitor Locating the Rating Labels Installing from the CD Installing the DriverOperating the Monitor Downloading from the Worldwide WebFront Panel Controls Setting the Optimal ResolutionAdjusting the Monitor Settings OSD Menu OSD Menu Selections2OSD Menu Using the Auto-Adjustment Function Using the Auto-Adjustment Pattern Software Select Models Solving Common Problems TroubleshootingLocating the Rating Labels Using the Worldwide Web Preparing to Call Technical SupportTable B-1HP 15.6 LCD Monitors Technical SpecificationsEnergy Saver Feature Recognizing Preset Display ResolutionsEntering User Modes Plug & Play DDC2B Feature Federal Communications Commission Notice Agency Regulatory NoticesModifications CablesAvis Canadien Canadian NoticeEuropean Union Regulatory Notice Japanese Power Cord Requirements Japanese Notice Korean Notice Power Cord Set RequirementsGerman Ergonomics Notice Energy Star Compliance Product Environmental NoticesMaterials Disposal Chemical SubstancesRestriction of Hazardous Substances RoHS LCD Monitor Quality and Pixel Policy
Top Page Image Contents