HP Vectra VL 5/xxx 5 Mass-Storage Drives, Hard Disk Drives, Flexible Disk Drives, CD-ROM Drives

Page 57

3 Interface Devices and Mass-Storage Drives

Mass-Storage Drives

Mass-Storage Drives

The IDE controller is described on page 34. The flexible disk controller is described on page 26.

Hard Disk Drives

A 3.5-inch hard disk drive is supplied on an internal shelf in some models.

 

2.5 GB IDE

1.6 GB IDE

 

 

 

HP product number

D2784-69001

D4621-69001

 

 

 

Manufacturer

Quantum

Quantum

 

 

 

Product name

Fireball TM 2550

Fireball TM 1700

 

 

 

Flexible Disk Drives

A 3.5-inch, 1.44 MB flexible disk drive (D2035B) is supplied on the top front-access shelf of all models.

CD-ROM Drives

Most models have a 8IDE CD-ROM drive (D4381A) supplied in a 5.25-inch front-access shelf.

 

8IDE

 

 

HP product number

D4381A

 

 

Manufacturer

Hitachi

 

 

Product name

CDR-7930

 

 

Formatted storage capacity

650 MB

 

 

If a disk is still in the drive after power failure or drive failure, the disk can be reclaimed by inserting a stout wire, not unlike a straightened paper-clip, into the dedicated hole at the bottom of the door.

In order to allow correct CD-ROM drive detection by the Setup program, leave the device configuration jumper on the rear connector in the cable select (CS) or master (MA) positions.

57

Image 57
Contents Technical Reference Manual Hardware and Bios Novell and Netware are registered trademarks of Novell Inc Preface ConventionsIii Bibliography Contents Matrox MGA Millennium Graphics Controller Board S3 Trio 64V2 Graphics Controller ChipPower Saving and Ergonometry Connectors and SocketsBios Addresses Mass-Storage DrivesViii Power-On Self-Test and Error MessagesSystem Overview Desktop Package PackageFront view of VL Rear view of XALine Mic Out Spkr Minitower PackagePlan view of the Chassis Base of the Desktop Package Physical Characteristics Specifications and Characteristic DataSystem Overview Specifications and Characteristic Data Status PanelEnvironmental Specification For the desktop models Electrical SpecificationInput voltage 100-127 For the minitower modelsVac 90-140Documentation Where to Find the Information System Board System Board Architectural View Chip-Set PL/PCI Bridge Chip 82439HXPL Bus Interface PCI Bus Interface Data PathController System Board Chip-Set PCI/ISA Bridge Chip 82371SB Serial / parallel Super I/O Chip 37C932Serial Eeprom Described onBytes of Cmos memory Desktop front view Desktop rear view Backplane boardsMinitower top view System Board Backplane boardsPCI slots normal PCI/ISA combination slotsISA slots full length ISA slots short length Intel Pentium Microprocessor Devices on the Processor-Local BusMMX Technology By Intel, are supportedSummarized on Bus FrequenciesMain Memory Cache MemoryError Correcting Code Operation Integrated Drive Electronics IDE Devices on the PCI BusThree DMA modes allow the following transfer rates Mode Cycle time ns 480 150 120 Transfer rate MB/s 13.3 16.7Heads per Bytes perUniversal Serial Bus USB Controller Devices on the ISA Bus Super I/O ControllerSerial Eeprom Updating the System ROM Flash Eeprom the System ROMSystem Board Switches NextRetained Little Ben Other PCI and ISA Accessory Devices Under Plug and PlayInterface Devices and Mass-Storage Drives S3 Trio 64V2 Graphics Controller Chip Video Memory100% compatible with IBM VGA display standard Standard VGA Modes Video ModesExtended Video Modes with 1 MB Dram Extended modes supported by the video Bios areExtended Video Modes with 2 MB Dram Available Video Resolutions Resolution Number of colorsMemory Troubleshooting ConnectorsMatrox MGA Millennium Graphics Controller Board Graphics processor chips Bottom half of upgrade socketVideo Memory 640 x 256, 64K, 16M 200 800 x 1024 x 120 1280 x 110 1600 x 1152 882 is not preset on HP displaysNumber 256 64 K 16.7 M 640 MB, 200 Hz 8001024 768 800 600 Video Bios1600 1280Sram HP Ethernet 10/100 BaseT Network BoardLook-Ahead Packet Processing LappDrivers HP Enhanced Ethernet Network Board MA capability of the special RPO power supply Audio ControllerInterface Devices and Mass-Storage Drives Audio Controller Operating system, and does not need such drivers Any of the parametersHard Disk Drives Mass-Storage DrivesFlexible Disk Drives CD-ROM DrivesConnectors and Sockets Audio Board Connectors TRST# CHCHK# Supply PwrGood RemoteOn+5 V supply Supply Reserved +12 V supply Ground Ground Data +Summary of the HP/Phoenix Bios Summary of the HP/Phoenix Bios HP/Phoenix Bios Summary HP/Phoenix Bios Summary3F8H Serial a System RAM 32 MB Processor type Pentium Bank a MB EDOBank B None 2F8H Serial BConfiguration Menu Setup ProgramSummary of the HP/Phoenix Bios Setup Program Main MenuAppears in a different color, and cannot be changed Enables or disablesExit Enter Select Sub-Menu F10 Previous ValuesSecurity Menu Power Menu Power-On from Space-Bar Power Saving and ErgonometrySoft Power Down Summary of the HP/Phoenix Bios Power Saving and ErgonometryMagic Packet Remote Power-On RPOActivity within the Setup Program Little Ben Index 11h, bit When set, computer mains button is disabled Signal Address DescriptionNetwork board still active ModeAdvanced Power Management APM Summary of the HP/Phoenix Bios Power Saving and Ergonometry Summary of the HP/Phoenix Bios Power Saving and Ergonometry HP Lock Desktop Management Interface DMIBios Addresses System Memory MapProduct Identification HP I/O Port Map I/O Addresses Used by the System1 022Fh Audio interface 1 Soundblaster 067Bh Parallel port 2 if ECP mode is selected024Fh Audio interface 2 Soundblaster 026Fh Audio interface 3 SoundblasterInterrupt Controllers DMA Channel ControllersPCI Interrupt Request Lines Bit Description Reserved read asPossible values are 3, 4, 5, 6, 7, 9, 10, 11, 12, 14 Power-On Self-Test and Error Messages Tests the LEDs on the control panel Order in Which the Tests are PerformedTo abort Process to abortError code to display and the boot process to abort Checksums. Test failure causes error codes to displayCauses an error code to display Test failure causes an error code to displayPorts. Test failure causes an error code to display Failure causes an error code to displaySystem will be configured for use Configured for useError Message Summary Lights on the Status Panel Beep Codes
Related manuals
Manual 16 pages 25.11 Kb

Vectra VL 5/xxx 5 specifications

The HP Vectra VL 5/xxx was a series of desktop personal computers introduced by Hewlett-Packard in the mid-1990s. These machines were designed for both business and professional environments, making them suitable for a range of applications from basic office tasks to more demanding computing needs. This series played a significant role in HP's efforts to strengthen its market presence in the PC sector during a time when competition was intensifying.

One of the standout features of the HP Vectra VL 5/xxx line was its versatility. The series included various configurations designated by the '5/xxx' nomenclature, which indicated different performance levels and specifications. The performance was driven primarily by Intel Pentium processors, widely acclaimed for their reliability and efficiency. This allowed users to choose a model that suited their specific requirements, whether for everyday tasks or more resource-intensive applications.

In addition to its strong processing capabilities, the Vectra VL 5/xxx featured advanced graphics support, which was critical for visual applications and presentations. Many units in this series came equipped with onboard graphics capabilities that supported a range of resolutions, enhancing the user experience in both standard office environments and more creative settings.

Storage options were another highlight of the HP Vectra VL 5/xxx series. The machines typically featured a variety of hard drive configurations, allowing for ample data storage. Some models included the option for expanding storage through additional hard drives or external devices. Coupled with considerable RAM options, these machines ensured smooth multitasking and efficient performance across various applications.

Connectivity was also a core aspect of the Vectra VL 5/xxx. The systems typically included multiple USB ports, parallel and serial ports, and integrated networking capabilities. This made it easy for businesses to integrate the Vectra machines into their existing infrastructure, facilitating seamless interaction with peripherals and networks.

In terms of design, the HP Vectra VL 5/xxx series presented a robust yet compact form factor, which was ideal for office environments with limited space. Additionally, HP emphasized the reliability and serviceability of these machines, which included easy access to internal components for maintenance and upgrades, thereby extending the product life cycle.

Overall, the HP Vectra VL 5/xxx line offered a balanced combination of performance, flexibility, and reliability, making it a solid choice for organizations looking to leverage computing power for a range of professional applications. The series embodied HP's commitment to delivering quality and innovation in the ever-evolving landscape of personal computing.