QuickSpecs
HP Smart Array P411 Controller
Technical Specifications
Dimensions (excluding | Low Profile PCIe Form Factor | |
bracket) | 19.05 cm x 24.13 cm x 5.72 cm (7.5 in x 9.5 in x 2.25 in) | |
Disk Drive and Enclosure | 6Gb/s SAS (Serial Attached SCSI) | |
Protocol Support - | 3Gb/s SATA (Serial AT Attachment) | |
Transfer rate | ||
| ||
SAS Connectors | 2 external (Mini SAS) x8 wide port connectors | |
Data Transfer Method | x8 5G PCIe 2.0 Express (4 GB/s maximum bandwidth) | |
Memory Bus Speed | ||
PCI | PCIe Express Gen 2.0 | |
Simultaneous Drive | 2 x4 Wide SAS Ports | |
Transfer Ports |
| |
SAS Port Link Rate | 24 Gb/s per x4 wide port connector (4 x 6 Gb/s) | |
Software upgradeable | Yes | |
Firmware |
| |
Cache Memory | ||
| available); transportable with | |
Logical Drives Supported | Up to 64 logical drives | |
Memory Addressing | ||
RAID Support | RAID 6, 6+0 (Advanced Data Guarding) | |
| NOTE: RAID 6, 6+0 can be enabled with either | |
| Minimum of 256 MB cache with Battery kit or FBWC and Smart Array Advanced Pack License key | |
| option upgrades | |
| Minimum of 512 MB BBWC or FBWC and Smart Array Advanced Pack License key option upgrades | |
| RAID 5, 5+0 (Distributed Data Guarding) | |
| NOTE: A minimum of 256 MB cache is required to enable RAID 5, 5+0 support of the Smart Array P411 | |
| RAID 1+0 (Striping & Mirroring) | |
| RAID 0 (Striping) | |
Upgradeable Firmware | Upgradeable Firmware with Recovery ROM feature | |
|
|
DA - 13202 Worldwide — Version 25 — November 1, 2013 | Page 17 |