HP ML370 manual Smart Array P410i Dimensions, Disk Drive, Enclosure Interface, Server Interface

QuickSpecs

HP ProLiant ML370 Generation 6

Technical Specifications

Smart Array P410i	Dimensions	Low Profile PCIe Form Factor
Controller	(not including bracket)	7.5 in x 9.5 in x 2.25 in (19.05 cm x 24.13 cm x 5.72 cm)
	Disk Drive and	6Gb/s SAS (Serial Attached SCSI)
	Enclosure Interface -	3Gb/s SATA (Serial ATA)
	Transfer rate
	SAS Connectors	2 internal (Mini-SAS) x8 wide port connectors
	Cache Memory Speed DDR2-800MHz with 40 or 72-bit wide bus provides up to 4.2 GB/s
		maximum bandwidth.
	Server Interface	x8 5G PCIe 2.0 provides 4GB/s maximum bandwidth
	SAS Speed	x8 3G SAS provides 2.4GB/s maximum bandwidth
	Cache Memory	40-bit 256MB ECC protected cache (72-bit 512MB BBWC module
		upgrades available); transportable with battery-backed upgrade
	Logical Drives	Up to 64 logical drives
	Supported
	Maximum Logical DriveGreater than 2TB
	Capacity
	Host Memory	64-bit, supporting greater than 4GB server memory space
	Addressing
	RAID Support	RAID 6, 6+0 (Advanced Data Guarding)
		NOTE: The minimum of 256 MB cache, battery kit, and Smart Array
		Advanced Pack License Key upgrade is required to enable RAID 6, 6+0
		RAID 5, 5+0 (Distributed Data Guarding)
		NOTE: The 256MB upgrade is required to enable RAID 5 support on the
		Smart Array P410i.
		RAID 1+0 (Striping & Mirroring)
		RAID 0 (Striping)
	Upgradeable Firmware Upgradeable Firmware with recovery ROM feature
NC375i Integrated	Network Interface	10Base-T/100Base-TX/1000Base-TX
Quad Port	Compatibility	IEEE 802.3 10Base-T
Multifunction Gigabit		IEEE 802.3ab 1000Base-T
Server Adapter		IEEE 802.3u 100Base-TX
		IEEE 802.3ad 1000Base-TX
		IEEE 802.1p 100Base-TX
		IEEE 802.1q 100Base-TX
	Data Transfer Method PCI Express, four lanes (x4)
	Controller	Qlogic/NetXen NX3031
	Network Transfer Rate	10Base-T (Half-Duplex)	10 Mb/s
		10Base-T (Full-Duplex)	20 Mb/s
		100Base-TX (Half-	100 Mb/s
		Duplex)
		100Base-TX (Full-	200 Mb/s
		Duplex)
		1000Base-TX (Half and	2000 Mb/s
		Full-Duplex)
	Connector	RJ-45
	Cable Support	10Base-T	Categories 3, 4 or 5 UTP up to 328 ft (100 m)
		100Base-TX	Category 5 or higher UTP; up to 328 ft (100
			m)
		1000Base-TX	Category 5 or higher UTP; up to 328 ft (100
			m)

DA - 13242 Worldwide QuickSpecs — Version 21 — 3-29-2010 Page 49