York D2EG 060, D3EG 036 installation instructions General, Inspection, Reference, For Your Safety

Page 1

J

SUNLINE PLUS

 

 

 

 

GAS / ELECTRIC

 

 

SINGLE PACKAGE AIR CONDITIONERS

INSTALLATION INSTRUCTION Supersedes: 035-14832-002-A-0302

035-14832-003-A-0204

MODELS D2EG 048 & 060 and D3EG 036

(11 SEER)

GENERAL

YORK Model DEG units are single package air conditioners with gas heat designed for outdoor installation on a rooftop or a slab.

The units are completely assembled on rigid, permanently attached base rails. All piping, refrigerant charge, and electrical wiring is factory-installed and tested. The units require only electric power, gas piping and duct connections at the point of installation.

The gas-fired heaters have aluminized steel tubular heat exchangers and spark ignition with intermittent pilot.

This appliance is not to be used for temporary heating of buildings or structures under construction.

INSPECTION

As soon as a unit is received, it should be inspected for possible damage during transit. If damage is evident, the extent of the damage should be noted on the carrier's freight bill. A separate request for inspection by the carrier's agent should be made in writing. Refer to Form 50.15-NM for additional information.

REFERENCE

Additional information on the design, installation, operation and service of this equipment is available in the following reference forms:

55.70-N1 -General Installation

55.70-N2 -Pre-start & Post-start Check List

530.18-N1.2V -Economizer Accessory

530.18-N1.13V -Man. Outdoor Air Damper Accy 0-35%

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.

If you smell gas:

1.Open windows

2.Don't touch electrical switches.

3.Extinguish any open flame.

4.Immediately call your gas supplier.

530.18-N1.14V -Man. Outdoor Air Damper Accy 0-100%

530.18-N1.12V -Motorized Outdoor Air Damper Accy.

530.18-N1.8V

530.18-N2.11V

530.18-N8.2V

530.18-N8.3V

530.18-N8.4V

530.18-N8.12V

690.15-N25V -CoilGuard-Low NOx Accessory-High Altitude Accy. (Natural Gas)-High Altitude Accy. (Propane)-Gas Piping Accessory-Propane Conversion Accessory-Low Ambient Accessory

Renewal Parts:

Refer to Parts Manual for complete listing of replacement parts on this equipment.

All forms referenced in this instruction may be ordered from:

Standard Register

Toll Free Tel.: 877-318-9675

Fax: 877-379-7920

APPROVALS

Design certified by CGA and UL listed as follows:

1.For use as a forced air furnace with cooling unit.

2.For outdoor installation only.

3.For installation directly on combustible flooring or, in the U.S.A., on wood flooring or Class A, B, or C roof covering material.

4.For use with natural gas and/or propane (LP) gas.

Not suitable for use with conventional venting systems.

Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal in- jury and/or equipment damage may result if installation procedure is not handled properly.

CAUTION

THIS PRODUCT MUST BE INSTALLED IN STRICT COMPLIANCE WITH THE ENCLOSED INSTALLATION INSTRUC- TIONS AND ANY APPLICABLE LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES

WARNING

INCORRECT INSTALLATION MAY CREATE A CONDITION WHERE THE OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY, PROPERTY DAMAGE AND/OR DEATH.

WARNING

DE-ENERGIZE THE ELECTRICAL POWER AND TURN OFF THE GAS SUPPLY TO THE UNIT BEFORE ATTEMPTING TO INSPECT, REPAIR OR PERFORM MAINTENANCE TO THE UNIT.

Image 1
Contents General For Your SafetyInspection ReferenceTable of Contents Installation Power and Control Wiring Service AccessFilters Condensate DrainWith Optional BELT-DRIVE Bracket Disconnect Switch Bracket for UnitsPipe Sizing GAS PipingGAS Connection External SHUT-OFFPropane UNITS, Tanks and Piping LOW NOx ApplicationOptional Economizer Rain Hood Vent and Combustion AIR HoodsSide Duct Application ShownPhysical Data DEG CFM RPM Model AIR Flow855 815 903 860 950 905 988 940 1022 970 894 885 940 980 1014 1020 1047 1095884 815 925 850 964 880 1001 910 864 770 908 805 948 835 987 870Blower Circuit Size Breaker DEG Supply Motor Ampacity Static ResistancesMIN MAX RLA LRA FLA AmpsAIR Flow Legend Utilities Entry DataDetail a Detail BCooling System OperationPreliminary Operation Cooling Cooling Sequence of OperationSTART-UP Supply AIR AIR Blower and Temperature Rise Adjustments Burner AIR Shutter AdjustmentPilot Checkout Burner InstructionsGAS Rate Cubic Feet PER Hour Checking GAS InputNatural GAS Seconds Size of Test Dial For One Cu. ftNormal Maintenance MaintenanceCleaning Flue Passages and Heating Elements StructionsTroubleshooting Troubleshooting