HP Connection Point 2W manual Network cables

Symptom	Possible Cause	Solution
Cannot access	Network cables	Verify that network cables are properly
Connection	not properly	connected at both ends and that
Point CP-2W	connected to the	Connection Point CP-2W is
configuration	PC or the	plugged in. The Connection Point CP-2W
pages through	Connection Point	act LEDs should be flickering on
an Ethernet	CP-2W.	corresponding cable connections
adapter.		when PCs are on and connected.
Cannot access	SSID and WEP	From a PC connected through Ethernet,
the	code on PC and	connect to the web-based configuration
Connection	Connection Point	page. Click the Advanced Setup tab.
Point CP-2W	CP-2W are	Verify that SSID and WEP key values on
configuration	different.	the web page match wireless
pages through		configuration utility values. To access
a wireless		your wireless adapter utility, refer to
adapter.		wireless adapter documentation. Change
		the value(s) of SSID or WEP on the PC or
		Connection Point CP-2W so that the
		values match.
	Wireless card not	Check signal strength indicator provided
	receiving radio	with your wireless LAN card. See network
	signal.	card documentation for more information.
		If no signal exists or signal very low, try
		moving adapter or Connection Point
		CP-2W to improve the signal strength.

USER GUIDE 77