HP 8000 s manual Fuser Life LOW

Printer unit control panel messages (continued)

Control panel message	Recommended action
FUSER LIFE LOW	Although printing can continue, the fuser
REPLACE KIT	should be replaced for optimum printer unit
	operation.
FUSER LIFE OUT	Replace the fuser kit and reset the fuser
REPLACE KIT	counter before attempting to print.
INPUT DEVICE	Close the media transfer door.
PAPER PATH OPEN
INSTALL <COLOR> TONER	Insert the cartridge or make sure the installed
	cartridge is fully seated in the printer unit.
INSTALL FUSER	Install the fuser and verify that it is properly
LOWER LEFT DOOR	seated in the printer unit before attempting to
	print.
INSTALL IMAGING DRUM	Install the imaging drum before attempting to
OPEN FRONT DOOR	print.	Printing
INSTALLTRANSFER DRUM	Install the transfer drum before attempting to
OPEN RIGHT DOOR	print.
LOCK TONER LEVER	Open the front door of the printer unit, open
	the clear door, swing the blue lever to the left
	to lock it. Close the clear door and the front
	door.
MANUALLY FEED	Load the correct type and size media into
<TYPE> <SIZE>	Tray 1.
OFFLINE	Press GO to bring the printer unit online.
POWERSAVE ON	Clear this message by pressing any key or by
	sending a print job to the printer unit.
PROCESSING	No action is required.
COPY <X> OF <Y>
PROCESSING JOB	No action is required.
TONER LOW	Although printing can continue, the toner
REPLACE <COLOR>	cartridge should be replaced for optimum
	printer unit operation.

EN Common messages 29