HP Cassette Player DDS-3 manual Chapter

Page 11

Chapter 1

Introduction

This document describes the HP DDS-3 drive (HP model number C1537A), its installation, operation, troubleshooting, and removal/replacement procedures.

This chapter introduces the DDS-3 drive and contains the following information:

General description of the drive

Preparing to install the drive

Preparing the system

Powering off the workstation and any peripherals

Adding or removing the DDS-3 drive bezels or expansion brackets

1±1

Image 11
Contents HP DDS-3 Tape Drive Users Guide 10 9 8 7 6 5 4 3 2 Contents Appendix a Scsi Connector Pinouts Using the DDS-DC DriveTroubleshooting and Removal/Replacement Procedures Tables FiguresAudience PrefaceCanadian Department of Communications CDC Safety and Regulatory StatementsFederal Communications Commission FCC Emissions Regulations Compliance Electrostatic Discharge ESD PrecautionsRelated Manuals Installation NoticeLiteral values Questions, Suggestions, or ProblemsDocumentation Conventions Chapter ±1. HP DDS-3 Drive General DescriptionVibration Ambient TemperatureDDS-3 Drive Environmental Requirements HumiditySuspended Particles ShockAltitude Transportation±2 describes the physical specifications of the DDS-3 drive DDS-3 Drive Physical SpecificationsOperating System Support Preparing to Install a New DDS-3 DriveVerifying Kit Contents Tools RequiredSetting the SCSI-2 Address Address Jumpers PWR ±4. Switch Settings for Data Compression Operation Mode Usr/sbin/ioscan Return Preparing the System# /etc/shutdown -h Return SCSI-2 Connection and TerminationPowering Off the Workstation and Any Peripherals ±5. Adding a Bezel to the DDS-3 Drive ±6. Removing a Bezel from the DDS-3 Drive ±7. Adding or Removing Expansion Brackets Using the DDS-3 Drive Controls and Features of the DDS-3 Drive Your DDS-3 Drive ConfigurationData Cassettes LEDsCleaning the Tape Heads ±2. Setting the Write-Protect Tab on a DDS Tape Loading and Unloading a Data Cassette Using the DDS-3 DriveUsr/sbin/ioscan -d stape Return Verifying the DDS-3 Tape Drive OperationMedia Interchangeability Restrictions DDS-DC DDS-2 DDS-3 Tape Length Full Height 5 1/4Ordering Information Troubleshooting and Removal/Replacement Procedures Checking the Address Settings for Single-Ended Drives TroubleshootingChecking the Hardware Installation # /etc/shutdown -h Return Man cstm Return Man mstm Return Man xstm Return Rechecking the Address SettingsFollowing screen appears Messages similar to the following appear Cstm verify all ReturnDescription Removal/Replacement ProceduresPowering Off the System Field Replaceable UnitsRemoving and Replacing the DDS-3 Drive ±1. Adding a Bezel to the DDS-3 Drive ±3. Adding or Removing Expansion Brackets Appendix a Index Index-2 HP DDS-3 Tape Drive Users Guide Order Number A1658±90702 Edition