HP Cassette Player DDS-3 manual DDS-3 Drive Physical Specifications

Page 15

Introduction

DDS-3 Drive Physical Specifications

Figure 1±2 describes the physical specifications of the DDS-3 drive.

+

+

+

4 mm

60 mm

 

(0.15 in.) 21 mm

(2.34 in.)

 

(0.82 in.)

90 mm

 

 

 

 

(3.51 in.)

 

41.3 mm

(1.61 in.)

101.6 mm (3.96 in.)

150 mm (5.85 in.)

++

101.6mm

(3.96 in.)

++

 

70 mm

30.9 mm

(2.73 in.)

 

(1.20 in.)

 

41.3 mm

(1.61 in.)

5mm (0.20 in.)

94mm

(3.66 in.)

3.8mm

(.15 in.)

Figure 1±2. HP DDS-3 Drive Physical Specifications

1±5

Image 15
Contents HP DDS-3 Tape Drive Users Guide 10 9 8 7 6 5 4 3 2 Contents Using the DDS-DC Drive Troubleshooting and Removal/Replacement ProceduresAppendix a Scsi Connector Pinouts Tables FiguresAudience PrefaceSafety and Regulatory Statements Federal Communications Commission FCCCanadian Department of Communications CDC Emissions Regulations Compliance Electrostatic Discharge ESD PrecautionsRelated Manuals Installation NoticeQuestions, Suggestions, or Problems Documentation ConventionsLiteral values Chapter ±1. HP DDS-3 Drive General DescriptionVibration Ambient TemperatureDDS-3 Drive Environmental Requirements HumiditySuspended Particles ShockAltitude Transportation±2 describes the physical specifications of the DDS-3 drive DDS-3 Drive Physical SpecificationsOperating System Support Preparing to Install a New DDS-3 DriveVerifying Kit Contents Tools RequiredSetting the SCSI-2 Address Address Jumpers PWR ±4. Switch Settings for Data Compression Operation Mode Usr/sbin/ioscan Return Preparing the System# /etc/shutdown -h Return SCSI-2 Connection and TerminationPowering Off the Workstation and Any Peripherals ±5. Adding a Bezel to the DDS-3 Drive ±6. Removing a Bezel from the DDS-3 Drive ±7. Adding or Removing Expansion Brackets Using the DDS-3 Drive Controls and Features of the DDS-3 Drive Your DDS-3 Drive ConfigurationData Cassettes LEDsCleaning the Tape Heads ±2. Setting the Write-Protect Tab on a DDS Tape Loading and Unloading a Data Cassette Using the DDS-3 DriveVerifying the DDS-3 Tape Drive Operation Media Interchangeability RestrictionsUsr/sbin/ioscan -d stape Return DDS-DC DDS-2 DDS-3 Tape Length Full Height 5 1/4Ordering Information Troubleshooting and Removal/Replacement Procedures Checking the Address Settings for Single-Ended Drives TroubleshootingChecking the Hardware Installation # /etc/shutdown -h Return Man cstm Return Man mstm Return Man xstm Return Rechecking the Address SettingsFollowing screen appears Messages similar to the following appear Cstm verify all ReturnDescription Removal/Replacement ProceduresPowering Off the System Field Replaceable UnitsRemoving and Replacing the DDS-3 Drive ±1. Adding a Bezel to the DDS-3 Drive ±3. Adding or Removing Expansion Brackets Appendix a Index Index-2 HP DDS-3 Tape Drive Users Guide Order Number A1658±90702 Edition