Led

LED and Beeper Indications

The scanner’s beeper sounds and its LED illuminates to indicate various functions or errors on the reader. A “Green Spot” also lights to indicate a good read. The tables below list these indications. One exception to the behaviors listed in the tables is that the reader’s functions are programmable, and may or may not be turned on. For example, certain indications, such as the power-up beep can be disabled using programming barcode labels. Refer to the PG for a more detailed list.

Indication

Beeper

Power-up	LED flashes/blinks on power-up, however, this
	may be too rapid to view. With a USB interface,
	the LED blinks until enumeration with the host
	is completed.

Scanner beeps four times at highest frequency and volume upon power-up.

Good Read	LED behavior for this indication is configurable	One beep at current frequency, volume, mono/
	using the PG.	bi-tonal setting and duration upon a successful
		label scan.

ROM Failure	200ms on / 200ms off	Scanner sounds one error beep at highest
		volume for 200 mS.

Limited Scanning Label	Not Applicable	Scanner 'chirps' six times at the highest
Read		frequency and current volume.

Scanner Disabled	The LED blinks continuously 100mS on /	Not Applicable
	900mS off.

ENWW	LED and Beeper Indications 7

LED and Beeper Indications

LED

Power-up

ENWW