HP ap5000 Base Model Point of Sale System, ap5000 Point of Sale System Setting Up the Scanner

Page 7

1 Setting Up the Scanner

Follow the steps below to set up the scanner.

1.Connect the interface cable to the bottom of the scanner. Figure 1-1Connecting/Disconnecting the Cable

2.Connect the other end of the interface cable to a USB connector on the host device. Figure 1-2USB Interface Connection

3.Aim the scanner at the barcode and press the trigger. Figure 1-3Aiming and Scanning

ENWW

Image 7

Contents HP Linear Scanner First Edition October Document Part Number About This Guide Iv About This Guide Table of contents Chemical Substances Restriction of Hazardous Substances RoHS Setting Up the Scanner Enww Scanning Modes Using the ScannerTrigger Single Mode Parts of the ScannerTrigger Pulse Multiple Mode Trigger Hold Multiple ModeFlashing Mode Always On Stand ModeTrigger Object Sense Programming Barcodes Resetting the Product Configuration to DefaultsUSB Interface LED LED and Beeper IndicationsSolving Common Problems TroubleshootingPreparing to Call Technical Support Cables Agency Regulatory NoticesFederal Communications Commission Notice ModificationsAvis Canadien Canadian NoticeEuropean Union Regulatory Notice Materials Disposal Japanese Notice Korean Notice Product Environmental NoticesProduct Environmental Notices SJ/T11363-2006