HP 3325A, 3325B manual Pin

Page 23

TB 9-6625-2049-35

By Order of the Secretary of the Army:

Official:

ERIC K. SHINSEKI

General, United States Army

Chief of Staff

JOEL B. HUDSON

Administrative Assistant to the

Secretary of the Army

0029703

DISTRIBUTION:

To be distributed in accordance with IDN 342200, requirements for calibration procedure TB 9-6625-2049-35.

PIN: 052316-000

Image 23

Contents Models 3325A and 3325B Forms, Records, and Reports Section Identification and DescriptionProgrammed amplitude at 1 kHz Section Equipment Requirements Spectrum Analyzer Preliminary Instructions Equipment SetupSection Calibration Process Entry Amptd 20 dBm Entry DC Offset Volt Entry Freq 20 MHz Harmonic Distortion a. Performance CheckIN/OUT 50 Hz Entry Amptd Volt Signal on Entry Freq 25 kHz Entry Amptd VoltEntry Freq MHz Entry Amptd Volt Entry DC Offset Square Wave Characteristics Performance CheckAmplitude Modulation Distortion a. Performance Check Entry Freq 10 kHz Entry Amptd Volt Entry Freq MHz Entry Amptd RMSRamp Retrace Performance Check Entry Freq 60 MHz Frequency Accuracy Performance CheckEntry Freq 20 MHz Entry Amptd Volt SIG Input AdjustmentsEntry Freq 100 kHz Entry Amptd 13 dBm Entry PhaseBlue then Asgn Zero Phase Entry Amptd RMS Entry Freq 100 Hz Amptd CAL Sine wave Amplitude and Flatness Performance CheckEntry DC Offset Volt Press Entry Amptd key Entry DC Offset Entry Freq KHz Entry Amptd RMS Amptd CALSquare Wave Amplitude and Flatness Performance Check Triangle and Ramp Amplitude Performance Check KHz Entry Amptd RMS Amptd CALDc Offset Performance Check 100 Hz Amptd CALDc Offset with Ac Performance Check High Voltage Output Option 002 only Performance Check Entry Freq KHz Entry Amptd RMS Amptd CAL Power SupplyEntry Freq 100 kHz Entry Amptd RMS Amptd CAL Power supply assembly A2 test instrument top view Final ProcedurePIN