HP Thunderbolt 2-Port AiO Module ESXi/ESX manual Fio-update-iodrive

oDate of manufacture

oPower loss protection status

oPCIe bus voltage (average, minimum, maximum)

oPCIe bus current (average, maximum)

oPCIe bus power (average, maximum

oPCIe power limit threshold (watts)

oPCIe slot available power (watts)

oPCIe negotiated link information (lanes and throughput)

•Block device information

oManufacturer code

oManufacturing date

oVendor and sub-vendor information

oFormat status and sector information (if device is attached) o FPGA ID and Low-level format GUID

o PCIe slot available power

o PCIe negotiated link information

o Card temperature, in degrees Centigrade o Internal voltage, average and maximum o Auxiliary voltage, average and maximum

o Percentage of good blocks, data and metadata o Lifetime data volume statistics

o RAM usage

Error mode information

If the IO Accelerator driver is in minimal mode, read-only mode, or write-reduced mode when the fio-statuscommand is run, the following differences occur in the output:

•Attach status is Status unknown: Driver is in MINIMAL MODE

•The reason for the minimal mode state appears. (For example, Firmware is out of date. Update firmware.)

• Geometry and capacity information not available appears.

•No media health information appears.

fio-update-iodrive

Description

IMPORTANT: The IO Accelerator devices must be detached before running the fio-update-iodrivecommand. To detach the devices requires rebooting with auto-attach disabled or using fio-detach. For details, see "fio-detach (on page 32)."

The fio-update-iodriveutility updates the HP IO Accelerator firmware. This utility scans the PCI-Express bus for all HP IO Accelerators and updates them all sequentially.

Utilities 36